5 / 9
USE OF THE FOG FLUID
Operate the Mega MaxTM / Mini MaxTM Fogger only with the MDG Glycol-based
Fog Fluids: the MDG DENSETM, the MDG MEDIUMTM or the MDG LOW FOGTM.
Make sure that no other liquids or particles are mixed or added to the MDG Fog
Fluid.
The MDG Glycol-based Fog Fluids produce a pure, white, non-toxic fog. Use of
this Fogger with any other fog liquid will automatically void the warranty. MDG
Glycol-based Fog Fluids are available at authorized MDG distributors or dealers.
REPLACING THE FLUID CONTAINER
Verify the fluid level of the bottle by looking through the opening, on the side of
the Fogger. If level is insufficient, change the bottle or refill.
WARNING –DO NOT OPERATE WITHOUT FLUID.
The fluid bottle capacity for the Mega MaxTM Fogger is 5-litre.
The fluid bottle capacity for the Mini MaxTM Fogger is 2.5-litre.
OPERATING INSTRUCTIONS
The MDG Mega MaxTM / Mini MaxTM Fogger is quite easy to operate and require
no preventive maintenance. It is supplied with a remote control model: MM-s.
A remote control timer model: MM-t or the 2-channel DMX Interface model:
MM-x can be bought as an option.
When the MAIN POWER (208, 230 or 115 VAC) and the MAIN POWER
SWITCH is applied, the Fogger is placed in stand-by mode. When in stand-by
mode, most of the electronic controls are off (except for the three types of fail-
safe systems), waiting for the ON switch on the remote control to be activated.
USE OF THE REMOTE CONTROL FOG PRODUCTION
Connect the remote control to the XLR-5 connector on the back panel of the
Fogger.
When the ON switch is pressed, the red LED indicating that the unit is working
will light, as well as the yellow LED called HEAT, indicating the start of the
heating cycle which takes approximately 7 minutes. When the temperature
reaches a pre-adjusted level called the READY level (indicated by a green LED),
the HEAT yellow LED will turn off.
