MEGATRONIX CP 300 User manual

CP 300
3 CHANNEL
REMOTE CONTROL
KEYLESS ENTRY SYSTEM
MEGATRONIX
CALIFORNIA, U.S.A.

I: TRANSMITTER CODE-LEARNING
1. Disconnect jumper on control module PC board so that both
terminals are disconnected (open).
2. Connect jumper back so that jumper is now shorted (closed).
3. Parking lights will stay on for 2 seconds. Transmitter code-
learning must be done within this 2 second window.
4. Press and hold any button on new transmitter for 2 seconds.
5. Parking lights will flash 4 times to confirm code is learned.
5. For 2nd transmitter, repeat steps 1 – 4.
II: OPERATION
1．Button 1 – Lock Button:
Channel 1: Press button 1 on remote. Signal will be given to
LOCK relay. Parking lights will flash once. Output timing will
be 1 second.
2．Button 2 – Unlock Button:
Channel 2: Press button 2 on remote. Signal will be given to
UNLOCK relay. Parking lights will flash twice. Output timing
will be 1 second.
3．Button 3 – Trunk Button:
Channel 3: Press button 3 on remote. Negative (300ma)
signal will be given to PURPLE wire to control external relay.
Parking lights will flash three times. Output timing will be 1
second.
III: CONTROL MODULE SETTINGS
1．Lock / Unlock Timing:
Jumper Disconnected: Timing is 0.8 seconds (Standard door
locks).
Jumper Connected: Timing is 3.5 seconds (Vacuum door
locks).
IMPORTANT
USE DIAGRAM 1 NEGATIVE TRIGGER FOR DAKIT2 / DAKIT4 LOCK KITS
USE DIAGRAM 2 POSITIVE TRIGGER FOR DSP / TRM SOLENOID KITS