Memphis VIV SIXFIVE Series User manual

Amplifier Instructions

• Brushed anodized aluminum finish
• 7-Color selectable color changing LED logo (Reversible)
• Super-efficient full range class D topology
• Bass boost up to 18dB
• Digital Signal Processing (DSP) with 48 dB crossover slopes
• LED Illuminated end caps with ground lighting.
• M-Equalization allows Bass Boost, Freq and Q to be dialed in (MONO Only)
• Optional wireless bass remote (VIV1300.5 and MONO models only) Part number: VIVREMV2
24 dB Crossover Slopes
24

900W @ 1 Ohm on 5th Channel*
125W x 4 + 500W x 1125W x 4 + 500W x 1
900W @ 1 Ohm on 5th Channel*
* VIV1300.5V2 & VIVBELLE Amplifiers are 1Ωstable on the 5th channel only. Only operate 5th channel at 1Ω when running 2 of the other
channels at 2Ωor higher. Do not run all full range channels at 2Ωwith 5th sub channel at 1Ω, doing so may damage the amplifier.

Bandpass lter
Band pass crossover:
With the crossover switch in the “BP” setting, you can use both the low pass and high pass adjustments to create your custom band pass
filter. Use the HI-PASS adjustment to change the frequency point of the low-end slope. Use the LO-PASS adjustment to change the frequency
point of the high end slope.
This feature allows you to custom tune the sound of your mid-range speaker. You can match the size and frequency response of your mid-range
speaker to the amp allowing you to get the most out of your speakers.
HI-PASS adjustment LO-PASS adjustment

@memphiscaraudiousa
@memphiscaraudio
www.memphiscaraudio.com