Mercku Tech M2 Bee User manual

MESH Node
Set-up
Guide

Thank you for choosing the Mercku M2 router
Set-up in 3 steps

1. Connect to the power and WAN cables
Red light indicates that there is power.
When the device has a internet connection,
the light will turn green.

MERCKU-XXXX
Wi-Fi-XXXX
Wi-Fi-XXXX
Use your mobile device or computer to search for
and connect to the MERCKU-XXXX Wi-Fi network
(no password required).
2. Connect to Wi-Fi
MERCKU-XXXX is generated from the device’s serial number - to find
this, please locate at the bottom.
*

3. Open browser or app
Visit mywifi.mercku.tech through a browser to complete setup.
Or scan the QR code to download the app to complete
the setup and manage the network.

Reset
Light
Pins
Thank you for choosing the Mercku M2 Bee node
Set-up in 1 step
Need help setting up your M2 router?
Please scan this QR code:
Or visit: www.mercku.tech/help
You need a working M2 router
to use the M2 Bee mesh node.

After you install the M2 Wi-Fi
router, you will only need to
plug in the Bee nodes and the
mesh system will be created
automatically.

If the Bee node fails to connect to the mesh
system or there is no internet, the Bee’s
indicator light will be red and steady. Please
check the network status of the M2 host router
or shorten the distance between the Bee node
and the other nodes (Bees or M2s)
*
After the mesh system is created successfully,
the Bee node’s indicator light will turn green
and stop blinking.
*
If the Bee node’s indicator light blinks, it means
that the signal is weak. Please move the Bee
node closer to the other nodes (Bees or M2s) in
the mesh network.
*
Too far

Control your mesh network
from anywhere, anytime
Download the Mercku app

If you want to connect the Bee
node to a different M2 Wi-Fi router,
from a separate package, please
follow the instructions from the
link below:
www.mercku.tech/help
www.mercku.tech/help
Need help?