Advantech B+B Smartworx SEC510-2SFP-T User manual

Product Overview
Hardware Installation
LED Status
Terminal Blocks
1
3
2
DIN Rail Mounting
Wall Mounting
Terminal Description
V2- Power Input 2 (DC Ground)
V2+ Power Input 2 (12 to 48VDC)
P-Fail Power Fault Relay
P-Fail Power Fault Relay
V1- Power Input 1 (DC Ground)
V1+ Power Input 1 (12 to 48VDC)
10/100/
1000
Ports
10/100
Ports
LEDs
Power
LEDs
Reset
Console
Wire Gauge: 12-24 AWG (3.31 - 0.205 mm2).
Torque: 7lb-in.
NOTE: P-Fail Relay is closed if both power input ports
are powered. The default is open.
LED Status Description
SYS
Green Normal operation
Off System down or initializing
operation
R.M. Green Active when determining
Ring Master
PWR1 Green Power Applied
Off No Power
PWR2 Green Power Applied
Off No Power
Alarm
Red Power is applied to one input
but not both inputs
Off No Power or Power is
applied to both inputs
LNK
Solid Link established
Blinking Data present
Off Not connected to Network
SPD
Green 1000M speed
Amber 100M speed
Off 10M speed

Recommended Accessories
MDR-40-24
Power Supply
C5UMB3FBG
Ethernet Cables
Document number – SEC510-2SFP-T_1017qsg
1-888-948-2248 | Europe: [phone]
advantech-bb.com
707 Dayton Road | PO Box 1040 | Ottawa, IL 61350
Phone: [phone] | Fax: [phone]
www.advantech-bb.com | E-mail: [e-mail]
Before you begin, be
sure you have the following:
SEC510-2SFP-T
Industrial Managed Ethernet Switch
Fast and easy on the web: www.advantech-bb.com
+ Ethernet Switch
+ DIN Rail Mount Bracket (Installed)
+ Power Supply (Required not included)
QUICK START
GUIDE
Troubleshooting
Default Settings
IP Address: 192.168.1.1
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.254
Username: admin
Password: admin
If no LEDs light, verify that the power supply
connections are solid and that power is present
on the output of the power supply.
Use the LED table to verify that power is
present, a link is established, data is being
transmitted, and to verify port speed.
If data does not pass and cable connections
have been veried, contact your Network
Administrator to validate that the network
connection is good.
The user manual can be found in the
documentation and download section of the
product web page.
-- First, go to www.advantech-bb.com.
-- Second, search for the model number.
-- Finally, go to the documentation/download
section of that product page to download
les.
Model # Description Temp Rating
SEC510-
2SFP-T
8-port 10/100Mbps + 2 GbE
Combo Full Managed
Ethernet Switch
-40 - 75 C