Mercury KOB WCAM301 User manual

3.4 Click “Finish” will restart computer
3.5 Then Plug in the KOB WCAM301 WebCam to the USB port
3.6 Windows will automatically detect the new hardware and configure the
device
Copyright Notice
© Copyright 2005, Kobian Group
All rights reserved.
Specifications and features subject to change without notice.
All trademarks and/or registered trademarks are properties of their respective owners.
KOB WCAM301
Web Digital Camera
User’s Manual
1. Introduction
z1/4 inch sensor, 6 mm lens, 5 Components 5 Glasses (4G+IR Cut Filter),
60 degree visual angle
z380000 pixels dynamic image: CIF (352×288) format, frame rate up to
30 fps; VGA (640×480) format, frame rate up to 15 fps
z4 infrared bearing lamps for night function
zAuto-illumination in low light condition
zFocusing range: 5cm to infinity
zVideo data format: 8/16/24bit. RGB 24
zTWAIN drive supports all kinds of video conference software
zAutomatic exposure control / automatic white balance
zAdvanced digital picture control functions, such as color saturation,
contrast, and gamma watch, etc.
2. System Requirement
zWindows 98/ME/2000/XP
zUSB port in computer
z100Mhz Pentium Processor
z32MB memory(64MB recommended)
z20MB hard disk
z2D/3D display card with a minimal 4MRAM supporting and 16 bit color
z4x Speed CD-ROM

3. Installing the Driving Program
3.1 Put the driver CD into the CD-ROM and run the
D:\WebCam\301\SETUP.EXE.
3.2 As the window appears as below, click “NEXT” to continue
3.3 Click “Continue Anyway”