MHSC BLCS User manual

Contemporary Stone Kit
Installation Instructions
Model: BLCS, BLCS3
For use on Fireplace Models:
BLDV300/400/500
DVBL300/400/500
WARNING: Before installing, turn fireplace off and allow it to cool. Only a qualified service person should service or
repair the fireplace.
Kit Contents:
1, 9 Molded Stone Assembly
4, Single Stones
NOTE: When installing the BLCS or BLCS3 Stone Kit, you must also use the GLB/S/E/O/D Reflective Glass Kit. The
Model 300 fireplaces require 1 glass kit, the Model 400 & 500 fireplaces require 2 glass kits.
+4
STONEPINS

Installation Instructions
1. Place the 9 molded stone assembly (#1)
over the pins on burner. Make sure the
flat side is facing the back. (Fig. 1)
Pins
KT512
Figure 1
+4
STONEASSEMBLY

9 Molded Stone Assembly Set on Pins KT513
20301735 8/10 Rev. 2

220301735
+4
3TONE

2. Place stone #2, flat side down, on right
side against the stone assembly. (Fig. 2)
Stone #2
KT514
Figure 2
+4
3TONE

Stone #3
KT515
Figure 3
3. Place stone #3, flat side down,
next to stone #2 against stone
assembly. (Fig. 3)
+4
3TONE

Stone #4
KT516
Figure 4
4. Place stone #4, flat side
down, next to stone #3
against stone assembly. (Fig.
4)

3
20301735
+4
3TONE

Stone #5 KT517
Figure 5
5. Place stone #5, flat side down,
next to stone #4 against stone
assembly. (Fig. 5)
+4
'LASS

Glass
KT518
Figure 6
6. Place the GL glass media
(purchased separately)
over the floor and on
burner in between and
behind rocks covering all
ports. Make sure there is
only a single layer of glass
covering the ported areas.
7. Replace glass
door. Refer to
Homeowner’s
Manual. Light fire-
place.
NOTE: Adjust glass
media as needed to
achieve clean and
even yellow flame.
Figure 7
KT519

420301735
MHSC
149 Cleveland Drive • Paris, Kentucky 40361
www.mhsc.com