
Outdoor Lifestyles •Hearth Kit • 4072-179 Rev G • 1/2020
5
4Installation Instructions
A. Install the Stainless Burner Assembly
The burner assembly is shipped ready for right-hand gas
connection.
The air shutter is set at the factory at 1/8” for NG gas.
• Remove the existing cap or gas jet assembly from the
gas stub in your replace. Clean the threads using a wire
brush or steel wool. Apply Teon tape or joint compound
to the steel tting and attach the provided brass adapter
to the stub.
• Place the burner assembly in the replace. The burner
should be centered both front to back and side to side.
• Bend the provided gas connector to facilitate its installation
between the burner and the gas stub.
• Attach one end of the gas connector to the brass elbow
or safety pilot tting. Attach the other end to the brass
B. Place Lava Rock
• Place the desired amount of lava rock on the oor of the
replace.
C. Install the Logs
• Install the logs using the installation instructions beginning
on page 8-13.
• Light the burner as outlined in the operating section.
• Spread additional lava rock around the outside of the
burner on the oor of the replace. DO NOT cover any
part of the burner assembly.
D. Adjust the Pilot Flame
The pilot ame should be a soft blue color and should sur-
round the last 1/2 in. of the thermocouple tip. The pilot ad-
justment screw is located on pilot valve beside control knob.
Refer to Figure 4.3. If pilot ame must be adjusted, use a
standard slotted screwdriver to turn screw clockwise to re-
duce ame or counterclockwise to increase ame.
Pilot Adjustment Screw
Figure 4.3 Pilot Adjustment Screw
E. Important Safeguards
• Other Fuels
- Although your Hearth Kit is very realistic in appearance,
it is not a real woodburning re and must not be used
for burning any fuel other than natural or propane
gas.
- To avoid irreparable damage to the appliance and/or
personal injury, wood, matches, paper, garbage or any
other material must not be placed or thrown on top of
the logs.
• Appliance Safety
-To avoid personal injury, do not touch hot surfaces
when the appliance is operating.
-Always ensure that the replace screen is closed when
the appliance is operating.
-Close supervision is necessary when the appliance is
being used near children.
• Do not remove any of the attached metal plates, which
contain important safety and operating information.
• Keep the appliance area clear and free of all combustible
materials, gasoline and other ammable vapors and
liquids.
•A qualied service technician must perform installation
and repair. The appliance should be inspected and cleaned
annually by a qualied service technician. More frequent
cleaning may be required due to excessive lint, dust, pet
hair, etc. It is imperative that the control compartments,
burners and air passageways are unobstructed during
operation.
- Review proper placement of logs and lava rock.
- Check the wiring.
- Ensure there are no gas leaks.
- Ensure the ow of combustion and ventilation air is not
obstructed (front grilles and vent caps).
• Do not use a blower insert, heat exchanger insert or other
accessories not approved for use with this appliance.
Solid fuels shall not be burned in a replace where a
decorative appliance is installed.
• If glass doors are present, the glass doors must be fully
opened while appliance is in operation.
The pilot ame must
always be present
when appliance is
operating. It should
just touch the top of
the thermocouple.
Pilot ame appearance