Made in China
Attention
1. In the using of the remote, if the indicated lamp blinking quickly, pls change the
battery in time. Pls don’t use poor quality battery to avoid the leaking of battery
liquid to damage the remote controller.
2. Please keep your finger off the touch ring when installing the batteries, to improve
its sensitivity, and use the remote ( 3 seconds later ) after the batteries are installed.
Please reinstall the batteries, if the fouch ring is found low-sensitivity.
3. This 433MHz remote control system is precise electronic product; don’t use it in
humid, high temperature, dust and high voltage environment; Saving it at indoor, dry
and no static electricity environment.
4. Pls don’t use the remote controller on the wide-range metal or strong electromagnet-
ic wave area, otherwise, it will badly affect the controlling distance.
You can add an endless numbers of lights to a zone on the 8 channels remote by
linking the lights to different zones. This way you are completely flexible in creating
different group combinations. Below you can see some grouping examples.
Grouping of several lights
1 2 3 11 2
Remark:
1. The user can re-programme freely as needed. One remote can control countless
lamps or controllers, but one lamp or controller can only be controlled by four
remotes ( Max ).
2. Please check the battery installation and controller ( totally discharge the power ),
when you programme after switching off and switching on.
Linking Instructions
If the light not blink slowly, the linking failed, Pls switch off the light
again, and follow the above steps again.
Switch off the light,
after 10 seconds
switch on again
1 2
Power
3The light blink 3 times
slowly means the linking is
done successfully.
Power
When the light on, short press
any zone of " " 3 times within
3 seconds
Unlinking Instructions
If the light not blink quickly, the unlink failed, pls switch off the light
again, and follow the above steps to unlink again.
3The light blinking 10 times
quickly, means the unlinking
successfully.
Switch off the light,
after 10 seconds
switch on again
1When the light on, short press
" " 5 times within 3 seconds
2
Unlinking must be the same zone
with the Linking
Linking&Unlinking
Remark: The light can be working after linking with the remote controller.
ON OFFW
MS- S+
1 2
3 4
5 6
7 8
SuperLong Distance 433MHz
Link/Unlink
button
ON OFFW
MS- S+
1 2
3 4
5 6
7 8
SuperLong Distance 433MHz
Link/Unlink
button
Power Power
Light 1
Light 2
Light 3
Light 4
Light 5 Light 1
Light 2
Light 3
Light 4
Light 5 Light 1
Light 2
Light 3
Light 4
Light 5
