Mi-Light FUT092 User manual

User manual
Model:FUT092-FUT039
Brand:Mi.light
product introduction
FUT092 is a full touch RGB+CCT remote controller, designed by high
precision IC with more stable touching. Adopt 2.4G wireless technology,and
can control LED bulb, downlight and controller,etc.
Technical Data
Working Voltage: 3V(2*AAA battery)
RF: 2410-2472MHz
Modulation Method: FSK
Transmitting Power: 6dBm
Standby Power: 5uA
Control Distance: 20-30M
Size：138×56×20mm
Product Pictures

Product Function
When touching any button,LED indicating lamp will light.
Master ON/OFF:All ON/OFF,control the light ON/OFF
Colr Ring:Touch the color ring, choose and change the color you want
Colr temperatureLine:Touch the CCT slider, adjust the color temperature
Saturation Control:Touch the Saturation slider, adjust the color saturation
Brightness Dimming:Touch the Dimming slider, change the
brightness(1%-100%)
Speed+:Accelerate the present dynamic mode
Speed-:Slow the present dynamic mode
Mode:Choose dynamic mode
Zone ON/OFF:Zone ON/OFF button, control the light ON/OFF。
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.