MicroElektronika RELAY click G6D1AASI-5DC User manual

EN: This Datasheet is presented by the manufacturer.
Please visit our website for pricing and availability at www.hestore.hu.

1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
aligned correctly, push the board all the way
into the socket.
3. Plugging the board in
2 3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
Before using your click board™, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
Relay click Manual
ver. 1.00
0 100000 023129
RELAY Click™is an add-on board in
mikroBUS™form factor. It’s a compact and
easy solution for adding RELAY to your
design. It features two G6D1AASI-5DC
power PCB relay modules as well as two
screwterminals.RELAYClick™communicates
with target board microcontroller via
mikroBUS™ PWM (RL1) and CS (RL2) pins.
The board is designed to use 5V power
supply only. LED diode (Green) indicates
the presence of power supply.
RELAY click
Relay is an electrical switch used to
terminate or establish circuit using a low
power signal from a microcontroller. Relay
provides complete electrical isolation
between microcontroller and controlled
circuits. Use the RELAY Click™ board with
it’s two G6D1AASI-5DC relays to control
various devices with up to 5A, 250V AC/30V
DC loads.

8. Support
Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
Communication lines voltage level can be
in range between 1.8V and 5V. On-board
transistors are used to drive relays by
current sinking.
5. RELAY Click™ Board Schematic
CN1
CN2
LD3
LD1
LD2
REL1 G6D1AASIDC5
REL2 G6D1AASIDC5
V2
V1
VCC
VCCVCC
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
VCC
R3
2K2
VCC
C1
10uF
VCC
R1
10K
R2
2K2
D1
D2
VCC
R1
R2
Q2
PDTC114EU
R1
R2
Q1
PDTC114EU
MIKROBUS DEVICE CONN.
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.

6. Communication lines