Midas Touch MDL-3160 User manual

Confidential
1
All rights reserved. Midas Touch, Inc.
MDL-3160 Smart Drawer Lock User Manual
Lock : The handle groove is turned in the red dot
direction, which is the locked position.
Power on：Tap the sensor once and red light
will flash, then you will hear a beep. After leaving,
the light turns into blue.
Unlock : Press the sensor once until the light
turns into green and beeps. Afterwards, turn the
handle groove to 3:00 direction and register or
clear.
Register Mode : The manager is the first register, and only the
manager has the authority to clear.
Manager Registration：
Go to the unlocking place and wait for the lightturns into blue.
After turning into blue, press the fingerprint sensor until hearing
beep. →leave the sensor and the lightflashes blue and purple. →
Press the sensor again（Start to register）→the purple lightbeeps
→turns into blue→Repeat the action three times（You will hear a
beep after every successful sensing）→Green lightlasts after
successful scanning. →Long beep（Successful registration）→Turns
into blue light
User Registration：
Go to the unlocking place and wait for the light turns into blue.
After turning into blue, the manager should press the fingerprint
sensor until light flashes greenand turns into purple. →Leave the
sensor and the lightflashes red and blue. →The user could register
and the light turns into greenupon successful registration. It will
then turns into blueafter a long beep.
Clean-up Mode：

Confidential
2
All rights reserved. Midas Touch, Inc.
Go to the unlocking place and wait for the light turns into blue.
After turning into blue, the manager should press the fingerprint
sensor until light turning into purpleand beep.(do not leave the
sensor)→Press until the sensor lightturns into white →Leave the
sensor. →As the lightflashes blue and green, press the sensor twice
and you will hear two beeps. →Afterwards, the manager should press
the sensor until the lightflashes green, red, and blue.
( About 5 seconds) →The lightwill last white after successful
registration and beep, followed by flashing green lightthree times.
Notice：
Low power：Red LED light flashes three times at the same time and
beeps three times.
Charging：Red LED light lasts.
Full charged：Red LED light turns off.
When the operation fails, wait for every light to turn off and press the
sensor again. Restart the power to operate.
Contact
Midas Touch, Inc.
Tel : [phone]
Fax : [phone]
Email : [email protected]
Website : www.midastouchinc.com
Address : 17F-16, No.1, Sec.1, Zhongshan Rd,
Banqiao Dist, New Taipei City 22063, Taiwan