MIFI HX-G668A User manual

Amiline.com
HX-G668A
Quick Start Guide
-------------------------------------------------- version: 1.0 -------------------------------------------------

Amiline.com
Chapter 1 Product introduction
1.1 Package list
3G mini Gateway
Power adapter
Y-shaped USB cable
3.7V 1500mAh Li-ion battery
WAN/LAN adapter
1.2 Product appearance and LED indicators

Amiline.com
LED instructions:
Power Red Power switch on
Blue Recharge when power switch is off, LED off after recharge finishes
Purple Recharge when power switch is on
Battery Blue Power enough
Blue/Purple alternate Low power critical point
Purple Lower power and recharge is needed
Wi-Fi Blue Wi-Fi on, WAN/LAN cable unplugged
Red Wi-Fi off, WAN/LAN cable plugged
Purple Wi-Fi on, WAN/LAN cable plugged
Signal Red Signal weak
Purple Signal normal
Blue Signal strong
Mode Purple 2G network
Blue 3G network

Amiline.com
Chapter 2 Router Set-up
2.1 Hardware set-up
Before router’s set-up, please correctly link according to following steps. In order to
achieve product’s wireless functions, please put the router in the middle of covered area.
1. Power supply for router. Supply methods: battery, power adapter, PC.
Power recharging method introduction:
(1) Supply by power adapter or PC, power off. Now recharge only, when recharging
finishes, battery light off.
(2) Supply by power adapter or PC, power on. Recharge while in use.
2. Power on

Amiline.com
3. Through USB connector, insert Data card into router.
4. Make sure WIFI function is on and works normal, connect to router through WIFI.

Amiline.com
Chapter 3 Administration Interface
Log-on
This chapter mainly introduces how to use router settings. After confirming wireless
connection to device, please set up the router according to following steps.
1. Open Web browser, input “192.168.1.1” in address bar, and press enter.
2. The following pop-up window, both input “admin” at “User name” bar and “Password”
bar, then press “OK” to enter administration page.
When you enter correct User name and password, click OK and enter administrator mode
main page.

Amiline.com
Note: router is compatible with WCDMA, EVDO, TD-SCDMA data cards, here is a
WCDMAdata card example.
Network info: Signal, currently registered network, ISP, connect status
：Signal ：ISP
：Network mode ：Disconnected
：Connected
Connect status: Displays current network upload and download speed rate, current
add-up network flow and sum-up network flow information.
WIFI management: Displays current WIFI name of router.
If you need to change it, click button and enter a
new name, then click “confirm”
Non-encrypted mode. Click the button to encrypt. Default
encryption mode: WEP, default password: admin. Click to
change the password.
Encrypted mode. Click the button and switch to non-encrypted
mode.
User Management: Displays User name and Password for log-on, which can be
manually modified.

Amiline.com
Chapter 4 Load Default Settings
You need to reconstruct the network or you forget the changes of some parameters, you
can choose to restore factory defaults and reconfigure the device.
1. Reset: Press and hold it for 5 seconds to restore the factory defaults, 1 second to
reboot device.
Note: After this operation, all configurations are restored to the defaults.
2. Log on to Web admin page, click “Administration”-“Settings Management”, click “Load
Default”.