MikroTik Routerboard NetMetal 5 User manual

This User Manual covers NetMetal models:
NetMetal 5,
NetMetal 5SHP,
NetMetal 5 triple,
NetMetal 5SHP triple.
The NetMetal is a solid and waterproof outdoor device. It has a high power wireless interface, and one
Gigabit Ethernet connector, which supports MDI-X auto-detection. The device has two or three RP-
SMA connectors for connecting external antennas (depends on model). The device is packaged with a
24 V power adapter, a PoE injector, and two mounting loops. There are four models available – two
Three-chain devices (with miniPCIe slot and without), and two Dual-chain models (with miniPCIe slot
and without). Extra places for more RP-SMA connectors are available on the unit in this case.
First use
1. Connect the device to the included PoE injector with Ethernet cable;
2. Connect the PoE injector into the computer;
3. Connect the power adapter to the PoE injector;
4. Download WinBox configuration tool https://mt.lv/winbox;
5. Default IP: 0.0.0.0, user name: admin and there is no password (or, for some models, check user and
wireless passwords on the sticker), use Neighbors tab and connect through MAC address;
6. DHCP Client enabled on the bridge;
7. Once connected configure the device, so it has an active Internet connection https://mt.lv/configuration;
8. Upgrade the RouterOS software to the latest version https://mt.lv/upgrade;

9. In the "QuickSet, CPE" menu set up the following: Choose your country, to apply country regulation
settings;
10.Set the antenna gain, depending on the antenna used;
11.Set up your router password in the bottom field.
Mounting
The NetMetal is designed to be used outdoors and mounted on pole or DIN rail.
When mounting, please ensure that the cable feed is pointing downwards.
The IP rating scale of this device is IP66. We recommend using Cat6 shielded cables.
Warning! This equipment should be installed and operated with a minimum distance of 20 cm between
the device and your body. Operation of this equipment in the residential environment could cause radio
interference.
Mounting and configuration of this device should be done by a qualified person.
The mounting hose clamp is provided with the package.
1. Guide hose clamp through the opening on the back of the device.
2. Attach to the pole or mast.
3. Align and secure by hose clamp screw using PH2 screwdriver.

The device should be always placed by TOP cover facing upwards.
When mounting on the DIN rail, please find a special bracket in the package and secure it with four
screws to the back of the unit.
With the attached mounting bracket you will be able to slide the device on the DIN rail.
Powering
The ethernet port accepts passive Power over Ethernet 8-30 V DC. The package contains a 24 V
adapter and a PoE injector. The maximum power consumption of the device is 21 W at 24 V.
Configuration
The device is configured as a bridge, with all interfaces bridged and DHCP Client enabled.
RouterOS includes many configuration options in addition to what is described in this document. We
suggest starting here to get yourself accustomed to the possibilities: .
In case IP connection is not available, the Winbox tool (
to the MAC address of the device from the LAN side (all access is blocked from the internet port by
default).

Expansion Slots and Ports
Built-in 5GHz 802.11ac/a/n wireless, AP/station/bridge modes supported (for CPE, AP, PtP modes)
One 10/100/1000 Gigabit Ethernet port, supporting automatic cross/straight cable correction (Auto
MDI/X), so you can use either straight or crossover cable for connecting to other network devices. The
Ethernet port accepts 8-30 V DC powering from a passive PoE injector.
One USB 2.0 or 3.0 port (depends on model) for extra storage or 3G/4G modem
Buttons and Jumpers
The reset button has three functions:
Hold this button during boot time until the LED light starts flashing, release the button to reset
RouterOS configuration (total 5 seconds).
Keep holding for 5 more seconds, LED turns solid, release now to turn on CAPs mode for managing
the unit from a CAPsMAN server (total 10 seconds).
Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the
RouterBOARD look for Netinstall servers (total 15 seconds).
Operating System Support
The device supports RouterOS software with the version number at or above what is indicated in the
RouterOS menu /system resource. Other operating systems have not been tested.
We recommend clicking the "Check for updates" button and updating your RouterOS software to the
latest version to ensure the best performance and stability.
To avoid pollution of the environment, please separate the device from household waste and dispose of
it in a safe manner, such as in designated waste disposal sites. Familiarize yourself with the procedures
for the proper transportation of the equipment to the designated disposal sites in your area.
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a commercial installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used
with the unit to ensure compliance.
Antenna Installation WARNING: It is the installer's responsibility to ensure that when using the
authorized antennas in the USA (or where FCC rules apply); only those antennas certified with the
product are to be used. The installer should configure the output power level of antennas, according to
country regulations and per antenna type. Professional installation is required for equipment with
connectors to ensure compliance with health and safety issues.
Approved Antenna Table:
Antenna Model Type Antenna gain,
dBi
UNII-1 (5150-5250 MHz) and UNII-3 (5725-5850MHz)
MT-482016/N/A Omnidirection
al 8.5
PA58-24-ANT Panel 24
HDDA5W-32-DP2 Dish 32
UNII-2A (5250-5350 MHz) and UNII-2C (5470-
5725MHz)
HGO-antenna-
OUT
Omnidirection
al 7
MTAS-5G-
19D120 Sector 19
*The same type of antenna and lower antenna gain than those listed above in the table may also be
used in accordance with certification.

Innovation, Science and Economic Development
Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science,
and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following
two conditions: (1) This device may not cause interference. (2) This device must accept any
interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes : 1) L’appareil ne doit pas
produire de brouillage; 2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [A] est conforme à la norme NMB-003 du Canada.
CAN ICES-003 (A) / NMB-003 (A)
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
Les dispositifs fonctionnant dans la bande de 5 150 à 5 250 MHz sont réservés uniquement pour une
utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites
mobiles utilisant les mêmes canaux.
Antenna Installation WARNING: It is the installer's responsibility to ensure that when using the
authorized antennas in Canada (or where IC rules apply); only those antennas certified with the product
are to be used. The installer should configure the output power level of antennas, according to country
regulations and per antenna type. Professional installation is required for equipment with connectors to
ensure compliance with health and safety issues.
Approved Antenna Table:
Antenna Model Type Antenna gain, dBi
UNII-1 (5150-5250 MHz) and UNII-3 (5725-5850MHz)
MT-482016/N/A Omnidirectional 8.5
PA58-24-ANT Panel 24
HDDA5W-32-DP2 Dish 32
UNII-2 (5250-5350 MHz) and UNII-2-Extended (5490-5600 MHz, 5650-5730
MHz)
HGO-antenna-OUT Omnidirectional 7

Antenna Model Type Antenna gain, dBi
MTAS-5G-19D120 Sector 19
*The same type of antenna and lower antenna gain than those listed above may also be used in
accordance with certification.
UKCA marking
Eurasian Conformity Mark
Частотный диапазон Мощность передатчика
5150-5350 МГц, 5650-
5850 МГц ≤100 мВт
*Доступные частотные каналы могут различаться в зависимости от модели продукта и
сертификации.
Информация о дате изготовления устройства указана в конце серийного номера на его наклейке
через дробь. Первая цифра означает номер года (последняя цифра года), две последующие
означают номер недели.
Изготовитель: Mikrotikls SIA, Aizkraukles iela 23, Riga, LV-1006, Латвия, [email protected].
Сделано в Китае, Латвии или Литве. Cм. на упаковке.
Для получения подробных сведений о гарантийном обслуживании обратитесь к продавцу.
Информация об импортерах продукции MikroTik в Российскую
Федерацию: https://mikrotik.com/buy/europe/russia
Продукты MikroTik, которые поставляются в Евразийский таможенный союз, оцениваются с
учетом соответствующих требований и помечены знаком EAC, как показано ниже:

Norma Oficial Mexicana
Rango de frecuencia (potencia de salida máxima): 5725-5850 MHz (30 dBm). Los canales de
frecuencia disponibles pueden variar según el modelo y la certificación del producto.
EFICIENCIA ENERGETICA CUMPLE CON LA NOM-029-ENER-2017.
La operacion de este equipo esta sujeta a las siguientes dos condiciones:
Es posible que este equipo o dispositivo no cause interferencia perjudicial y.
Este equipo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operacion no
deseada.
Fabricante: Mikrotikls SIA, Brivibas gatve 214i, Riga, LV-1039, Latvia.
País De Origen: Letonia; Lituania; China (Republica Popular); Estados Unidos De America; Mexico.
Por favor contacte a su distribuidor local para preguntas regionales específicas. La lista de
importadores se puede encontrar en nuestra página de inicio
–https://mikrotik.com/buy/latinamerica/mexico.
The National Commission for the State
Regulation of Communications and
Informatization by Ukraine
Виробник: Mikrotikls SIA, Brivibas gatve 214i Рига, Латвія, LV1039.
Робоча частота (Максимальна вихідна потужність): 5150-5250 МГц (23 дБм), 5250-5350 МГц (20
дБм), 5470-5725 МГц (27 дБм).
Справжнім Mikrotikls SIA заявляє, що маршрутизатор відповідає основним вимогам та іншим
відповідним положенням директиви 2014/53/EC, а також суттєвим вимогам Технічного
регламенту радіообладнання, затвердженого постановою Кабінету Міністрів України від 24
травня 2017 року № 355.
Для експлуатації в Україні необхідно отримати дозвіл на експлуатацію у порядку, затвердженому
рішенням НКРЗІ від 01.11.2012 № 559, зареєстрованому в Міністерстві юстиції України
03.01.2013 за № 57/22589.
CE Declaration of Conformity
Manufacturer: Mikrotikls SIA, Brivibas gatve 214i Riga, Latvia, LV1039.

Hereby, Mikrotīkls SIA declares that the radio equipment type RouterBOARD is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following
internet address: https://mikrotik.com/products
WLAN
Operating Frequency / Maximum output power
Betriebsfrequenz / maximale Ausgangsleistung
Fréquence de fonctionnement / puissance de sortie
maximale
Frequenza operativa / massima potenza di uscita
Frecuencia de funcionamiento / potencia de salida máxima
Рабочая частота / максимальная выходная мощность
5470-5725 MHz / 27
dBm
Note. The information contained here is subject to change. Please visit the product page
on www.mikrotik.com for the most up to date version of this document.