EN
5
- Inspect the machine for possible faults.
oYou must inspect the safety systems to ensure that they are working properly
before you start using the machine.
oCheck that all moving parts are in good condition, that they work properly and
that there are no bindings. All parts must be correctly installed and comply with
all standards to ensure proper operation of the machine.
oDamaged parts and protectors must be replaced or repaired by a specialized
workshop.
oIf the warnings printed on the machine are damaged or illegible, they must be
replaced immediately.
Electrical safety
- The electrical connections must comply with the CEI 60245 (H 07 RN-F) standard, and
the cable must have a section of at least: 400 V 3~ 5 x 1.5mm2 for a maximum 10m
cable.
- Never use the machine with a power cord longer than 10m, as they will cause a drop
in voltage. The engine will not be able to be at full capacity and its operation will be
affected.
- Plugs and extension cords must comply with current regulations. For example, made
of rubber, plasticized PVC or another thermoplastic material with the same mechanical
stability, or covered with this material.
- The connection joint of the extension must be waterproof.
- When extending the extension cord, make sure it does not twist, bend, or interfere with
other tasks. Make sure it doesn't get wet.
- Unwind the cable completely if you are using a spool extension.
- Do not use the cable for purposes for which it was not designed. Protect the cable from
heat, oil and any sharp objects. Do not pull on the cord to unplug the machine.
- Inspect extension cords frequently and replace if damaged.
- Do not use defective extension cords.
- When working outdoors, use only extension cords that are approved and marked as
suitable for this type of work.
- Do not mount temporary electrical connections.
- Do not disable or bypass electrical safety measures.
Attention
The electrical connection and repairs to the electrical parts of the machine must be carried out
by a certified electrician or at one of our service points. You must comply with local regulations,
especially those referring to preventive measures.
Repairs to other parts of the machine must be carried out by the manufacturer or at one of our
maintenance points.
Use only replacement parts approved by the manufacturer. The use of unsuitable parts may
cause accidents. The manufacturer will not be held responsible for damage or injury caused
by the use of inappropriate parts.
1.2. Scope of supply
After unpacking the product, check the contents of the box:
- Equipment previously assembled
- Right control stick
- Left control stick
- 2 wheels
