Millenium WS30 User manual

Thomann GmbH · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de
DocID: 378752_19.04.16
ö
#
$
%
1/2
Studio Desk WS30
Assembly instructions
For mounting the studio desk, use the
supplied screws and washers. Use a soft
padding to avoid damage to the compo-
nents.
1. Screw the support brackets for the
lower table top with each one metric
screw at the desired height on both
side panels.
2. Screw the lower single strut to the
support for the upper table top with
each two metric screws between the
two side panels.
Then screw the rack frame with four
metric screws right and left on the
side panels and on the support for the
upper table top.
3. Screw the central strut to the brackets
for the keyboard shelf with each two
metric screws beneath the support
brackets for the lower table top bet-
ween the side panels.
Screw the two xing brackets for the
keyboard shelf with each two metric
screws properly orientated on the
middle strut.
4. Screw the keyboard shelf with each
two wing nuts on both xing brackets.

Thomann GmbH · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de
DocID: 378752_19.04.16
'
&
(
2/2
Studio Desk WS30
For the transport and protective packaging,
environmentally friendly materials have been
chosen that can be supplied to normal
recycling. Ensure that plastic bags, packaging,
etc. are properly disposed of. Do not just
dispose of these materials with your normal
household waste, but make sure that they are
fed to a recovery. Please follow the notes and
markings on the packaging.
Ensure that plastic bags, packaging, etc. are disposed of
properly and are not within reach of babies and young
children. Choking hazard!
Because of its heaviness, at least two people are always requi-
red for the transport and installation of the studio desk.
Technical specications
Materials used:
– steel sheet (side panels, struts)
– wood (table tops)
Dimensions (W×H×D):
1930×1270×1070mm
Weight: 40kg
5. Screw the larger lower tabletop cente-
red with wood screws to the two sup-
port brackets and the smaller upper
tabletop equally to the upper support.
6. Assemble the two monitor tables at
the sides as shown and put them into
the two brackets.
7. Screw the brackets of the monitor tab-
les with each two metal screws on the
side panels.
Loosen the handscrews on the bra-
ckets for aligning the monitor tables.