Milton & Goose Play Kitchen Hood User manual

Contact us at: [email protected] www.miltonandgoose.com
ADULT ASSEMBLY REQUIRED
WARNING: Small Parts
Product contains small parts with potentially hazardous
sharp points and sharp edges in the unassembled state.
Keep unassembled parts away from children.
WARNING: Tipping Hazard
is toy has been rigorously tested to meet all toy tipping
safety standards; however, this toy is not meant to be
climbed on. Serious injury can occur with improper use.
• Do not allow children to climb on or
hang from this product
• Place product on flat, level surface only
• Do not place heavy objects on top of this product
• Keep back of this product against a flat wall
• Follow age guidelines for this product
Assembly Instructions
1. Upon opening package, please inspect contents to
make sure all parts and components are accounted for.
2. Place contents on padded or carpeted surface to avoid
damage.
3. Please read assembly instructions carefully.
Use and Care
Use on level surfaces only, and routinely check hardware
and tighten as necessary. Failure to maintain your new
product may result in unsafe conditions for children.
We build our toys with years of future play in mind, so to
ensure a long lifespan for your product, surface clean only
with a dry soft cloth. To clean small stains, use a slightly
damp cloth and if necessary, a mild detergent. Wipe all
spills immediately and avoid using any abrasive cleaning
agents or scrubs, including ammonia or alcohol based
formulas.
For more for information on how to care for your new toy,
please visit www.miltonandgoose.com.
A
C
D
Qty 12
Qty 3
!
!
B
Parts
1 hood (A)
1 backboard (B)
12 1½” screws (C)
3 pegs (D)
Play Kitchen Hood
Tools Required
Philips-head screwdriver
Play Kitchen purchased separately
8/14/2019

Contact us at: [email protected] www.miltonandgoose.com
Directions
Loosely attach all screws and then
tighten once all screws are in place.
Be careful not to over-tighten, otherwise
cracking of the wood can result.
!
B
C
B
A
C
D
Step 1
Insert all screws through pre-drilled holes first!
Attach backboard (B) with 6 screws (C) in pre-drilled
holes at back of backboard. Secure screws.
Step 3
Insert all screws through pre-drilled holes first!
Attach hood/shelf unit (A) with 3 screws (C) in
pre-drilled holes at back of backboard. Position so the
three pegs are hidden under the hood. Secure screws.
Step 2
Insert all screws through pre-drilled holes first!
Insert pegs (D) into backboard (B) and secure with
3 screws (C) in pre-drilled holes at back of backboard.
B