Mimosa FIRST CLASS TRAVEL SYSTEM User manual

Malaysia Importer/Distributor:
Global Product Solutions Sdn. Bhd. (705154-M)
Wisma Pang Cheng Yean, Lot 5205C,
Jalan Perindustrian Balakong Jaya 1/3,
Taman Perindustrian Balakong Jaya,
43300 Seri Kembangan, Selangor Darul Ehsan, Malaysia
Tel: [phone]
[email protected]
Hong Kong Importer/Distributor:
Trade Solutions Ltd
Unit D, 13A/F, Gemstar Tower, 23 Man Lok Street,
Hunghom, Kowloon, Hong Kong
Singapore Importer/Distributor:
Global Outsource Solutions Pte Ltd
601 Sims Drive, Pan-I Complex, Singapore 387382
Tel: [phone]
[email protected]
MIMOSA FIRST CLASS
TRAVEL SYSTEM
Stroller User Manual
This stroller is suitable from birth to 36 months and the maximum load is
15kg. This infant car seat is suitable from birth to 12 months and the
maximum load is 13kg. This travel system has been designed to comply
with EN1888:2012.
Important – Please read the instruction before assembly.
33lbs
15kg
Up to

CONTENTS
1. SAFETY INFORMATION.............................................................................................................1
2. FIRST CLASS TRAVEL SYSTEM PARTS..................................................................................3
3. ASSEMBLING THE STROLLER.................................................................................................5
4. SECURING THE HARNESS .......................................................................................................7
5. ADJUSTING BRAKES ................................................................................................................7
6. ADJUSTING RECLINE POSITION...........................................................................................8
7. ADJUSTING FOOTREST...........................................................................................................8
8. ADJUSTING HANDLE................................................................................................................9
9. FOLDING THE STROLLER.........................................................................................................9
10. USING INFANT CAR SEAT WITH STROLLER...................................................................10
11. CLEANING AND MAINTENANCE......................................................................................11
21
1. SAFETY IN FORMATION
Please read this user manual carefully before using this product.
Important - Keep these instructions for future reference.
• WARNING Never leave your child unattended.
• WARNING Ensure that all the locking devices are engaged before use.
• WARNING To avoid injury ensure that your child is kept away when
unfolding and folding this product.
• WARNING Do not let your child play with this product.
• WARNING Always use the restraint system.
• WARNING Check that the pram body or seat unit or car seat
attachment devices are correctly engaged before use.
• WARNING This product is not suitable for running or skating.
• WARNING This stroller is suitable for children from 0 to 36 months. The
max load of this stroller is 15kg. Never overload.
• WARNING The infant car seat is suitable for children from 0 to 12 months. The
max load of the car seat is 13kg. Never overload.
• WARNING Use the most reclined position of this stroller for new born
babies.
• WARNING The maximum permissible loading for shopping basket is 5kg.
• WARNING Any load attached to the handle and/or on the back of the
backrest and/or on the sides of this stroller will affect the stability of this
stroller.
• WARNING The stroller and infant car seat should only be used for one child at a
time.
• WARNING Accessories which are not approved by the manufacturer/
distributor should not be used.
• WARNING Only replacement parts supplied or recommended by the
manufacturer/ distributor should be used.
• WARNING The brake system must be engaged when placing your child in
this stroller or taking your child out of this stroller.
• WARNING Do not use if any part is broken, torn or missing.
• WARNING Avoid placing this product near naked heat sources such as
electric bar fires, gas fires, etc., or where a child could gain access to any
other kinds of hazards.
• WARNING When using the stroller, always use the crotch strap in combination
with the waist belt.
• WARNING Always use the harness provided and make sure the harness is
correctly fitted.
• WARNING Do not allow child to stand on the seat unit.
• WARNING Do not pull this product by bike, motorbike and car, or any
vehicle.

2. FIRST CLASS TRAVEL SYSTEM PARTS
3 4
Stroller frame
Handle bar
Release trigger
Brake lever
Shopping
basket
Front wheel
Footrest
5-point
harness system
Front bumper
Canopy
Rear wheel
Adjustment
button
Seat
Canopy Front bumper
Front wheels Rear wheels

3. ASSEMBLING THE STROLLER
5 6
1. First, unfold the stroller frame by
stepping on the rear tube and
pulling the handle bar upwards.
Next, push forward until the
folding hinge is fully engaged. The
folding mechanism will lock in
place when the legs are fully
extended.
2. To attach the front wheels, push
wheel into front leg tube until it
clicks into place. Repeat on the
other side.
To remove, press release button on
the side of wheel hub and pull
wheel from hub.
Note: Pull on wheels to ensure
both of them are securely attached
to the stroller.
3. To attach the rear wheels, push
wheel into rear frame until it clicks
into place. Repeat on the other
side.
To remove, press release button
and pull wheel from hub.
Note: Pull on wheels to ensure
both of them are securely attached
to the stroller.
4. To install the seat, align the seat
with the anchors on the sides of
the stroller frame. Click the seat
into place. The seat may be
installed in either forward or
rear-facing position.
5. Insert the front bumper into
connector on the stroller frame as
shown. Pull on the front bumper
to make sure it is attached
securely.
Note: The bumper must be
securely attached before using
this product.
6. Insert the canopy clips into the
slot located on each side of the
seat.
To open canopy, push forward
while holding the rear of canopy
in place. To close, push to the rear
of stroller.
Release button
To at tach To remove
Forward-facing Rear-facing
Close
Open
To at tach
To remove
Release button

4. SECURING THE HARNESS
6. ADJUSTING RECLINE POSITION
5. ADJUSTING BRAKES
7 8
The stroller seat has 3 recline
positions - upright, half-reclined
and fully reclined position.
Press the recline button at the
back of the seat and adjust the
seat into the desired position.
Front wheels
1. The front wheels are equipped
with a swivel locking device.
To lock, push the button down.
To unlock, push the button up.
7. ADJUSTING FOOTREST
Press the buttons on both sides of
the leg rest support to adjust up
and down until the desired
position.
L
Lock Unlock
Engage Release
Press
1. Slide the shoulder strap buckle ①
into the housing of the waist strap
buckle ②. Repeat on the other side.
Insert the completed buckle ③into
the crotch buckle ④until it engages
securely in place. Repeat on the
opposite side.
To release buckle, press the button
on the crotch buckle ④.
Rear wheels
2. To engage brakes, step on the
brake lever located on the rear
tube. If necessary, gently push the
stroller back and forth to fully
engage the brake.
Make sure the brakes are fully
engaged.
To release, gently lift up the brake
lever.
2. To change the shoulder strap
position, reach one hand behind the
stroller and pull the harness strap out
from the front of seat then re-insert
into the desired set of slots that is
closest to your child’s shoulder.
Repeat with other harness strap.
When re-inserting the harness straps,
Make sure to always place harness
straps at the same height setting.

8. ADJUSTING HANDLE
9. FOLDING THE STROLLER
10. USING INFANT CAR SEAT WITH STROLLER
910
1. Align the infant car seat with
the anchors on both side of the
stroller frame and push them into
the anchors until they click into
place.
Note: Infant car seat must face
parent as shown.
3. Make sure the front wheels lie
flat, then secure the stroller in the
folded position with the fold strap,
located on the right side of the
stroller through the rear frame.
2. Remove the infant car seat off
the stroller before folding the
stroller frame.
1. Before folding the stroller, close
the canopy and align the front
wheels parallel to the stroller.
Note: The stroller cannot be
folded which the seat is in
rear-facing (i.e. parent facing)
position
2. To fold the stroller frame, pull
both release triggers and press
handle down towards the floor.
To adjust the handle, press the
release buttons to move it up or
down into a comfortable position
for the user.
Note: Make sure the handle clicks
into place before using.
RE LEA SE B UT TO N
Press

11. CLEANING AND MAINTENANCE
11
Periodically check the stroller for damaged or worn parts. Do not use this stroller if any
part is damaged or worn.
Hard parts: It is recommended to clean moving parts regularly in order to maintain
correct functioning. Clean the frame with a soft damp cloth with mild soap.
Stroller fabric: Fabric parts may be cleaned in accordance with the fabric care label.
Don not machine wash. Stroller seat can be wiped clean with damp cloth if necessary.
Stroller seat and Basket: Wipe clean with damp cloth if necessary.
Cover: 100% Polyester
Do not leave the stroller exposed to heat e.g. open fire, heaters and other sources of
strong heat.
If the stroller frame has been exposed to salt water, please rinse the frame with clean
fresh water as soon as possible afterwards.
If the stroller is wet, leave it unfolded and allow all parts to dry completely to prevent
mould. Never store the stroller in a damp or hot environment.
DO NOT
IRON
DO NOT
DRY CLEAN
DO NOT
TUMBLE DRY
DO NOT
BLEACH
DO NOT
MACHINE WASH