MIOX RIO-S Series Operators Manual
102-00130-D Page 5
List of Figures
Figure 1: RIO-S On-Site Generator, 4 Cell Bank Configuration ........................................ 7
Figure 2: RIO-S OSG Space Requirements................................................................... 9
Figure 3: Front External View of RIO-S with Labeled System Components ...................... 12
Figure 4: RIO-S Major Plumbing Components (Non-Electrical) ...................................... 17
Figure 5: External plumbing connections required (3-way valve and Y-strainers not shown)
........................................................................................................................... 18
Figure 6: Electrical cabinet overview ......................................................................... 20
Figure 7: Main Power to RIO-S OSG.......................................................................... 21
Figure 8: Internal view of Controls Cabinet showing major electrical components ............ 22
Figure 9: Internal view of Switchgear Cabinet showing major electronic components ....... 24
Figure 10: Modules 1 & 2 M12 Designations............................................................... 25
Figure 11: Left View of RIO-S Showing External Connections (Cell Enclosure Hidden) ...... 26
Figure 12: Typical Cell Bank Wiring Diagram: Top View ............................................... 28
Figure 13: External Plumbing Electrical Overview: Rear ............................................... 30
Figure 14: External Plumbing Electrical Overview: Right (Outlet) .................................. 31
Figure 15: Modules 3, 4 & 6 M12 Designations ........................................................... 33
Figure 16: Module 5 M12 Designations...................................................................... 34
Figure 17: Brine Tank Float Assembly ....................................................................... 35
Figure 18: internal view of the brine tank with/without quartz rock bed ......................... 35
Figure 19: Brine Pressure Boost System.................................................................... 37
Figure 20: Oxidant tank assembly ............................................................................ 38
Figure 21: Oxidant Tank Safety Placard Locations....................................................... 39
Figure 22: Hydrogen Ventilation Requirements........................................................... 40
Figure 23: Oxidant Pressure Transducer Assembly ...................................................... 41
Figure 24: Level Switch Installation .......................................................................... 42
Figure 25: HMI Main Screen .................................................................................... 48
Figure 26: HMI Cell Bank Manual Enable/Disable Interface........................................... 52
Figure 27: Location of Water Control Valve Relative to Inlet/Outlet Plumbing Connections 61
Figure 28: Rupture Disk and Leak Detect Assemblies .................................................. 65
Figure 29: Ruptured Diaphragm ............................................................................... 66
Figure 30 Leak Detect Sensing Band Removal ............................................................ 67
List of Tables
Table 1: Feed Water Requirements........................................................................... 19
Table 2: Fault Conditions Descriptions....................................................................... 54
Table 3: Fault Conditions Troubleshooting Guide......................................................... 56
