miseno 232068-BAT-WH User manual

Free-Standing Bathtub
INSTALLATION GUIDE
BEFORE INSTALLING:
PLEASE CHECK TO MAKE SURE YOU HAVE
ALL PARTS REQUIRED FOR INSTALLATION.
TOOLS
REQUIRED
ADJUSTABLE
WRENCH
SPIRIT
LEVEL
TAPE
MEASURE
CAULKING
GUN
MARKING
PENCIL
Please retain this manual after installation for future
reference and maintenance.
IMPORTANT:
• Two people are required to install this bathtub.
• This freestanding tub is not designed to support
weight along its rim. Please do not sit or stand on it.
STEP 1
Set tub in installation location.
Adjust leveling legs with an adjustable wrench, and level
tub using spirit level.
Check for level across the top of the tub.
Check for plumb along drain side,
and then make sure tub is
resting solidly on all four feet
op
of
the
tub
.
i
n s
i
de,
e
et
STEP 2
Mark the floor with the outline of the
tub, or tub feet, with a marking
pencil to make it easier to reposition.

STEP 4
Carefully tilt the tub on its side and use a
flexible connector to connect the waste outlet
to the trap as illustrated.*
Reposition tub using pencil marks as a guide,
making sure that the flexible connector is not
kinked on installation, as this will result in
drainage issues.
RECEIVING YOUR TUB:
1. After receiving your tub, please unpack your tub, remove all covering, and check for manufacturer defects or
shipping damage. Damage claims will be rejected if notification is not made in a timely manner.
2. Protect your tub. If you are not installing your tub immediately, please repack it until time to do so. Scratches and
cracks caused by the customer or installer are not covered under warranty.
WATER TESTING:
1. Water test your tub immediately after installation, before sealing the tub seam with silicone. Ensure water drains
correctly and there are no leaks from the tub.
2. Water test overflow pipe and tub waste (drain) to ensure they also do not leak.
CLEANING AND MAINTENANCE:
1. To preserve the polished surface of your tub, clean regularly with a soft cloth and warm, soapy water.
2. Do not use powders, pastes, creme cleaners, thinners, or window cleaning sprays.
3. Stubborn marks or fine scratches may be polished out with Brasso polish.
4. Before using colored essential oils in your bath, first apply a drop of oil to an inconspicuous area on the tub to
check for staining. Always add essential oils to a full bath, never when empty.
REPAIRS:
Scratches and cigarette burns can be improved with 1200 grit wet/dry sandpaper and then repolished with Brasso
polish. Always polish scratches in a circular motion.
STEP 3
*Flexible connector and waste trap are not supplied and
must be purchased separately.
STEP 5
Apply silicone sealant around the tub base or
tub feet using caulking gun to prevent water
from seeping underneath.
Allow silicone to cure for 24 hours before using tub.
HOMEOWNER INFORMATION: