Mitsubishi Q Series User manual

Series HMI Connection Manual
134 V1.01 Revision November, 2011
Mitsubishi Q Series Ethernet
（Supports QJ71E71 / QJ71E71-B2 / QJ71E71-B5 / QJ71E71-100 Series Module）
HMI Factory Setting:
Baud rate: 192.168.0.1
Controller Station Number: 1025
Control Area / Status Area: D0 / D10
Connection
Standard jumper Cable/ Network Cable without jumper (Auto-detected by HMI)
Definition of PLC Read/Write Address
a. Registers
Format
Type
Word No. (n)
Read/Write Range Data Length Note
Input Xn X0 – X1FF0 Word Hexadecimal,
2
Output Yn Y0 – Y1FF0 Word Hexadecimal,
2
Internal Relay Mn M0 – M8176 Word 2
Special Internal Relay Mn M9000 – M9240 Word 3
Link Relay Bn B0 – B1FF0 Word Hexadecimal,
2
Annunciator Fn F0 – F2032 Word 2
Timer Value TNn TN0 – TN2047 Word
Counter Value CNn CN0 – CN2047 Word
Data Register Dn D0 – D8191 Word
Special Data Register Dn D9000 – D9255 Word
Link Register Wn W0 – W1FFF Word Hexadecimal
b. Contacts
Format
Type
Bit No. (b)
Read/Write Range Note
Input Xb X0 – X1FFF Hexadecimal

Series HMI Connection Manual
V1.01 Revision November, 2011 135
Output Yb Y0 – Y1FFF Hexadecimal
Internal Relay Mb M0 – M8191
Special Internal Relay Mb M9000 – M9255
Format
Type
Bit No. (b)
Read/Write Range Note
Link Relay Bb B0 – B1FFF Hexadecimal
Annunciator Fb F0 – F2047
Timer Contact TSb TS0 – TS2047
Timer Coil TCb TC0 – TC2047
Counter Contact CSb CS0 – CS2047
Counter Coil CCb CC0 – CC2047
NOTE
1) Before using this communication protocol, the user needs to set communication module
via GX Developer programming tools. For more detailed information regarding the
setting method, please refers to Mitsubishi PLC User Manual.
2) The device address must be the multiple of 16.
3) The device address must be the multiple of 16 plus 9000.

Series HMI Connection Manual
Settings
Screen Editor
1. HMI Configuration Setting
136 V1.01 Revision November, 2011

Series HMI Connection Manual
2. PLC Configuration Setting
V1.01 Revision November, 2011 137
GX Developer (V8.35M)
1. Network Parameter MNET/10H Ethernet Settings
Item Setting
Network Type Ethernet
Starting I/O No. 0000
Network No. 1
Group No. 1
Station No. 1
Mode On-line

Series HMI Connection Manual
138 V1.01 Revision November, 2011
2. Operation Settings
Item Setting
Communication Data Code Binary code
Initial Timing Always wait for OPEN
IP Address 192.168.0.1
Send Frame Setting Ethernet (V2.0)
Enable Write at RUN time Enable
TCP Living Confirmation Setting Use the KeepAlive
3. Open Settings
Item Setting
Protocol TCP
Open Method Unpassive
Fixed buffer Send
Fixed buffer communication procedure Procedure exist
Existence confirmation No confirm
Host Station Port No. 0401(HEX)
4. For more detailed information regarding the setting method, please refers to Mitsubishi PLC
User Manual.