MobileDemand Surface Go User manual

Surface Go Scanner Installation

2
Scanner only assembly for Surface Go
©2021 MobileDemand, LC | All trademarks are property of their respective owners.
1 - Shown are the parts included in the Scanner Only Kit
SG-SCN-ONLY-KIT-DFS.
2 -Install Tablet into t he Case pe r ins tr uc tions include d with Case.
Make sure the Scanner USB PCB does not extend into Case.
3 - Remove M3 x 8 & (2) M3 x 10 Flat Head screws.
Remove and keep M3 x 8
mm long Flat Head screw.
Remove and keep (2) M3 x 10
mm long Flat Head screws.

3
Scanner only assembly for Surface Go
©2021 MobileDemand, LC | All trademarks are property of their respective owners.
4 -Install the Scanner Filler Plate. 5 -Re-install the M3 x 8 and
(2) M3 x 10 Flat Head screws.
Scanner Filler Plate
M3 x 8
Flat Head Screw
(2) M3 x 10
Flat Head Screw
6 -Install the Scanner Connector Cover
using (2) M2 x 3 Pan Head screws.
Scanner Connector Cover
(2) M2 x 3 Pan Head Screws

4
Scanner only assembly for Surface Go
©2021 MobileDemand, LC | All trademarks are property of their respective owners.
7 -Locate USB Type C connector in tablet. 8 -Plug USB Type C PCB into USB Type C connector as shown.
USB Type C connector

5
Scanner only assembly for Surface Go
©2021 MobileDemand, LC | All trademarks are property of their respective owners.
9 -Install Vanity Cover over USB Type C PCB. Ensure wires are aligned in
Vanity Cover clearance area so that wires are not pinched. 11 - Vanity Cover should look like
this when properly installed.
10 - Install the M3 x 5 Pan Head screw.
Vanity Cover
Wire Clearance
area