MobileDemand xTablet T1270 User manual

1
User Manual
xTablet T1270
1501 Boyson Square Drive – Suite 101 Hiawatha, Iowa 52233 | PH: 319.363.4121 | RuggedTabletPC.com

xTablet T1270
2
User Manual
xTablet T1270
Contents
Copyright and Trademark Notice 3
FCC Information 4
IC Statements 5
Safety Instructions 6
Introduction 8
Product Overview 9
Specications 12
Power Supply 13
AC Adapter 13
Battery 14
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW

xTablet T1270
3
Copyright and Trademarks Notice
All marks and names mentioned may be trademarks of their respective owners. No warranty as to accu-
racy or completeness is expressed or implied. We reserves the right to make changes to this document
without prior notice.
Revision History
►Version: 1.0
►Date: 04, 2018

xTablet T1270
4
FCC-B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and radiates radio frequency
energy, and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
►Reorient or relocate the receiving antenna.
►Increase the separation between the equipment and receiver.
►Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
►Consult the dealer or an experienced radio TV technician for help.
NOTE
►The changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
►Shield interface cables and AC power cord, if any, must be used in order to comply with the emission limits.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
►This device may not cause harmful interference.
►This device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device was
tested for typical lap held operations with the device contacted directly to the human body to the back side of the notebook
computer. To maintain compliance with FCC RF exposure compliance requirements, avoid direct contact to the transmitting
antenna during transmitting SAR information 1.30 W/kg@1g (body).

xTablet T1270
5
CE Conformity
This device is in compliance with the essential safety requirements and other relevant provisions
set out in the European Directive.
Battery Regulations
European Union: Batteries, battery packs, and accumulators should not be disposed of as unsorted house-
hold waste. Please use the public collection system to return, recycle, or treat them in compliance with the
local regulations.
Taiwan: For better environmental protection, waste batteries should be collected separately for recycling or
special disposal.
California, USA: The button cell battery may contain perchlorate material and requires special handling
when recycled or disposed of in California.
For further information please visit: http://www.dtsc.ca.gov/hazardouswaste/perchlorate/
Safety Guideline for Using Lithium Battery
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recom-
mended by the equipment manufacturer. Discard used batteries according to manufacturer’s instructions.
WEEE Statement
European Union: Under the European Union (“EU”) Directive on Waste Electrical and Electronic Equipment,
Directive 2002/96/EC, which takes eect on August 13, 2005, products of “electrical and electronic equip-
ment” cannot be discarded as municipal waste anymore and manufacturers of covered electronic equip-
ment will be obligated to take back such products at the end of their useful life.

xTablet T1270
6
Read the safety instructions carefully and thoroughly. All cautions and warnings on the equipment or
user’s manual should be noted.
Keep this equipment away from humidity and high temperature.
The openings on the enclosure are used for air convection to prevent the equipment from overheating.
Do not cover the openings.
• Do not leave the equipment in an unconditioned environment with a storage temperature
above 60ºC (140ºF) or below -20ºC (-4ºF), which may damage the equipment.
• This unit should be operated under maximum ambient temperature of
50ºC (122ºF) or under 60ºC (140ºF) for light loading applications.
Followings are requirements of battery storage:
1. Storage temperature up to 3 months should remain between -20º ~45ºC ;
Storage temperature of 3 months to 1 year should remain between 23º± 2ºC.
2. The battery capacity should remain at 30 ± 5%.
3. The storage humidity should remain at 65 ± 25%RH.
4. The battery charging temperature 10º ~45ºC , discharging temperature -20º ~60ºC.
5. For the maximum battery discharging performance, storage temperature = 25ºC.
Make sure the power voltage is within safety range and has been adjusted properly to the value of
100~240V before connecting the equipment to the power outlet.
• Always unplug the AC power cord before installing any add-on card or module to the equipment.
• Always disconnect the AC power cord or uninstall the battery pack or switch o the wall socket if the
equipment would be left unused for a certain time to achieve zero energy consumption.
Place the power cord in a way that people are unlikely to step on it. Do not place anything on top of the
power cord.
Safety Instructions

xTablet T1270
7
Always keep strong magnetics or electrical objects away from the tablet.
To avoid damage or electrical shock never pour liquid into the opening.
If any of the following situations arise, have the equipment checked by a service personnel:
• The power cord or plug is damaged.
• Liquid has penetrated into the equipment.
• The equipment has been exposed to moisture.
• The equipment is no longer working properly.
• The equipment was dropped and damaged.
• The equipment has obvious signs of breakage.

xTablet T1270
8
Introduction
Congratulations on the purchase of MobileDemand’s xTablet®T1270. Designed and tested to meet our
exacting standards ensures dependability and customer satisfaction.
Refer to this manual to guide you through the basic functions and features.
Unpacking
Unpack the shipping carton and check all items carefully. If any item is damaged or missing contact your local dealer
immediately. Please keep the box and packing materials in the event you need to ship the unit. The package should
contain the following items:
• XTablet T1270
• AC/DC adapter and AC power cord
• Hand strap
• Brief case handle
• Stylus (optional)
• Stylus holder (optional)
• Quick Start Manual (optional)

xTablet T1270
9
Product Overview
4
3
2
1
1. Status LED
Power
• LED glows when the tablet power is turned on.
• LED ashes when the tablet goes to the sleep state.
• LED goes o when the tablet is turned o.
Drive Activity Indicator
• LED blinks when the system is accessing the
internal storage drives.
Battery
• LED glows green when the battery is being charged.
• LED turns glowing amber while the battery is in low ca-
pacity below 7% status.
• Continuously blinks amber if the battery fails. If the prob-
lem persists, please contact your local authorized retailer
or service center.
• Battery LED goes out when it is fully charged or when the
AC/DC adapter is disconnected.
2. Internal Microphone
3. Touch Screen
4. Camera

xTablet T1270
10
1. Barcode scanner (optional)
1. Dock Connector
2. Kensington Lock
3. Dock Guide Holes
1. DC-in Jack
2. Reset Hole
3. Headphone Jack
4. USB 3.0 Port
5. RJ-45 Connector
6. Micro HDMI Port
21
1 2 3 4 5 6
1
3

xTablet T1270
11
4
3
5
6
1 2
1. Battery Latch
2. Fan
3. NFC (optional)
4. Finger Print Reader (optional)
5. Function Key
F1 - Trigger Barcode Scanner
F2 - Enable/Disable Stealth Mode (Turns o LEDs, Wi-Fi, BT, LTE, Backlight, Speaker)
F3 - User Congurable within Predened Options
6. Rear Camera

xTablet T1270
12
Specications
The specications listed here is for reference only, and may change without notice.
DIMENSIONS 12.5”W x 8.4”H x 1.1”D
4.3lbs (1.95kg) - base cong
DISPLAY 12.2” Capacitive
1920 (W) x 1200 (H) resolution
Sunlight Viewable
CPU Intel® Core i5-7200U;
MEMORY 8GB Standard, 16GB (optional)
STORAGE 128 Standard, 256-512GB-1TB (optional)
O/S Windows 10 Professional 64-bit
RUGGEDIZED MIL-STD 810G (4’ drop)
1000x Tumble Test (pending)
Sealing IP65 (dust and water)
Screen Protector Oleophobic, scratch-resistant glass
Operating Temp 14° F to +122° F (-10° C to +50° C)
Storage Temp -4° F to +140° F (-20° C to +60° C)
Operating
Humidity
95% non-condensing
I/O PORTS USB Type A 3.0
HDMI Type D (Micro)
Ethernet
Power - DC Barrel Jack
Micro SIM Card Slot
MicroSD Slot
3.5mm Aux
BATTERY
SYSTEM
Standard: 7.6V, 6200 mAh / 47.12 Wh
Backup: 142 mAh
Up to 8Hr Battery life¹
Hot swappable
CAMERA Front - 2 MP
Rear - 8 MP
OPTIONAL 3D CAMERA CHARACTERISTICS
Model Intel RealSense D415 Camera
Technology Intel RealSense Vision Processor D4;
Intel RealSense module D415
Active IR stereo
Depth Field of View 69.4° x 42.5° x 77° (+/- 3°)
Output Depth stream resolution up to 1280x720; frame rate
up to 90 fps
Sensor Resolution RGB 1920x1080 at 30 fps
Sensor FOV 69.4° Horizontal x
42.5° Vertical x
77° Diagonal (+/- 3°)
Distance and
Range
Minimum depth - distance 0.3m
Maximum range - approximately 10m depending on
calibration, scene, and lighting condition
WIRELESS/NETWORK
WLAN 802.11 a/b/g/n/ac,
2.4G/5G
Bluetooth 4.2
GPS Ublox NEO-M8N onboard
Concurent reception of GPS/QZSS, GLONASS, BeiDou
4G LTE Sierra Wireless EM7565 (optional)
AGENCY
APPROVAL
FCC-CE-IC
¹Battery life varies signicantly depending on settings, app usage, and other factors

xTablet T1270
13
Getting Started
Power Supply
This section provides basic safety precautions when using an AC/DC adapter and battery.
AC/DC Adapter
Ensure the xTablet T1270 is connected to an AC power source via the AC adapter before turning it on for
the rst time. If the xTablet automatically shuts down due to low battery power, it is likely to cause system
failure. Below are some Dos and Don’ts for an AC/DC adapter.
►Dos
• Use the adapter that shipped with xTablet T1270 only.
• Always be aware of heat coming from the AC/DC adapter while in use.
• Unplug the AC power cord before disassembly the notebook.
►Don’ts
• Never cover an adapter that is in use as it can generate heat.
• Never leave the power cord plugged in after powering o the system.
1. Take up the interchangeable plug and look for the groove on the interchangeable plug which can be used for locking
on the AC/DC adapter. Then align the groove of the interchangeable plug on the tenon of the AC/DC adapter with
correct orientation. Next, rotate the interchangeable plug 90 degrees clockwise until it is xed on the AC/DC adapter.
2. Plug the DC end of the AC/DC adapter into the DC-in jack of the xTablet T1270.
3. Plug the AC/DC adapter into the power outlet.
4. When removing, follow steps in reverse order.
(NOTE:The interchangeable plug may vary depending on countries or regions.)

xTablet T1270
14
Battery
This Tablet is equipped with a built-in high-capacity Lithium-ion Polymer battery pack.
The rechargeable Lithium-ion Polymer battery pack is an internal power source.
The battery pack may be damaged if users attempt to disassemble it. The limited warranty will be
voided if the battery pack is disassembled by non-authorized technicians. Please follow your local
laws and regulations to recycle the Tablet and the built-in battery pack.
►Conserving Battery Power
Ecient battery power is critical to maintain normal operation. If battery power is not managed well, the saved data and
customized settings may be lost.
To optimize battery life and avoid sudden power loss, read the tips below:
• Suspend system operation if the system will be idle for a period of time.
• Disable unnecessary settings or remove idle peripherals.
• Connect an AC/DC adapter to the system whenever possible.
►Charging the Battery Pack
The built-in battery pack can be recharged when the Tablet is connected to the AC power. Please pay attention to the follow-
ing tips before recharging the battery:
• You can use the system, suspend system operation or shut down and turn o the system without interrupting the
charging process.
• The built-in battery pack uses Lithium-ion Polymer battery cells that have no “memory eect.” It is unnecessary to dis-
charge the battery before recharging. However, to optimize the life of battery, we suggest that consuming the battery
power completely once a month is necessary.
• The actual charging time will be determined by the applications in use.
(NOTE:Please do not charge battery in temperature below 0º or above 45ºC , it may cause safety issue.)

1501 Boyson Square Drive – Suite 101 | Hiawatha, Iowa 52233 | PH: 319.363.4121 | RuggedTabletPC.com