MODI T30-S User manual
User Guide
Motorcycle 4-Way Conference Intercom
Table of Contents
Introduction ---------------------------------------------- Page 1
Packet Contents ----------------------------------------Page 2
Install Instructions ---------------------------------------Page 3
Charging ---------------------------------------------------Page 5
General Operation Instructions -----------------------Page 5
FM Operation ---------------------------------------------Page 8
Universal Pairing and Using ----------------------------Page 9
Bluetooth Intercom Talk --------------------------------Page 10
Technical Specifications --------------------------------Page 16
Certification ----------------------------------------------Page 16
1
Introduction
Thank you for choosing the T30-S Motorcycle 4 Riders full-duplex stereo Bluetooth wireless
helmet headsets, designed for installing into most open-face, flip-front and full-face style helmets.
With the T30-S, you can call hands-free on your Bluetooth mobile phone, listen to music or voice
instructions of GPS navigation, and activate wireless intercom for rider to rider or rider to
passenger intercom talk within range of 2100 meters(Depending on terrain conditions).
The T30-S is compliant with Bluetooth Specification V4.2 supporting the following profiles:
Headset Profile(HSP), Hands-Free Profile(HFP), and Advanced Audio Distribution Profile
(A2DP), and Audio Video Remote Control Profile(AVRCP) and Audio Gateway (AG). It
supports universal pairing with most Bluetooth headsets on the market. The user can activate Siri
or S-Voice from the main unit for voice dialing and other voice commands. The FM radio tuner is
built into the main unit and allows for station scanning.
Superior audio fidelity has been achieved with our high fidelity, non-ported, and ultra-slim helmet
HD speakers. This headset also provides the industry’s best combination of wind and ambient
noise reduction with the miniature boom microphone.
Please read this User Manual carefully before using this product.
2
2: Packet Content
3
HIFI Speaker and Microphone
Type C USB Cable
Clip Mounting Bracket
User Guide
3: Install Instructions
1:Locate the helmet at the left and clean it up
2:Peel off the 3M rubber protective film
3:Apply pressure to the metal carrier to secure the holder firmly
Note: it takes 24 hours after drying.
Temporary installation method
1:Clip on the left edge of the helmet
2:Remove metal handle after installation
3:If required, use additional anti slip rubber patches
4
Install host
1:Slide T30-S host off the top of the clip and you'll hear a click when it is completely plugged in
2:Plug in the Type C headset plug
Headset mounting method
1:Stick the left and right horns of the headphones in the position of the left and right ears of the
helmet
2: Keep the microphone in front of the mouth，Note: microphone holes point to the mouth
5
4: Charging
1. You can charge with the Type C USB cable in the package. During charging, red light is on,
after full charging, the light will turn blue. It is recommended to recharge the battery before each
use. Suggest full charge before each use.
2. Low battery warning：Headset will automatically voice prompt low battery at every 5 minutes
to prompt the user to recharge it.
3. Battery state notify: When standby, long press Volume- button 1s to report battery level.
5: General Operation Instructions
Power on /Power off
Press and hold the Intercom button and Phone button for 2seconds to Power on or Power off
T30-S.
Pairing with Cell Phone or GPS and Using
Mobile Phone/GPS pairing steps
1. When power off，press Phone button for approx 6S, blue and red light flashing，headset enter
mobile phone pairing mode. Open the phone Bluetooth, search for “T30-S”, then click on the
phone connection pair.
6
Answer phone calling:
The unit will automatically answer the incoming call after 12 seconds. Or press Phone button to
answer the incoming phone call immediately.
Reject incoming call:
When have incoming calls, double press Phone button 2 times to reject within 12s。
End phone calling:
During talking, short press Phone button to end the call。
Voice dial:
When phone standby, double press Volume - button to make voice dialing (The phone itself must
have voice dialing function)
Last number redials:
When cell phone standby, double press Volume + button to make last number redialing.
Memory connects with cell phone:
Once pairing with cell phone, when power on again, headset will re-connect with mobile
automatically. Or in case disconnect during standby mode, short press Phone button will
connecting again.
Connect third party calls:
When connecting two cell phones, during phone call with first cell phone and second cell phone
dial in, can double press Phone two times to answer the second cell phone and hold the first cell
7
phone conversation. When finish the second cell phone conversation, will back to the conversation
with fist cell phone.
Reject third party calls:
When connecting two cell phones, during phone call with first cell phone and second cell phone
dial in, can short press button Intercom to reject the second cell phone.
Music Control:
Press the Phone button to play and pause the music. When playing music, double press Volume +
button to go to next track, double press Volume - button to go to previous track.
Music Sharing:
The T30-S that is playing music can share the music to another T30-S. When T30-S is playing
music, double-click the phone button of T30-S_1, T30-S_1 enters the music sharing state. When
T30-S_2 is in standby mode, double-click the phone key of T30-S_2, T30-S_2 will query and
connect T30-S_1, and then play it automatically T30-S_1’s music
Stop Music Sharing:
When the T30-S is in the music sharing state, double-click the phone key on the device to end the
music sharing.
Voice Volume Control:
Short press Volume + button or Volume- button adjust the voice volume. Or while music or talking
state, long press Volume+ button or Volume - button adjust the voice volume.
8
6: FM RADIO
Turn on/off radio
When in standby mode, press and hold button Phone 1 seconds to turn on FM radio. Press and
hold it again for 1 seconds to turn off FM radio.
FM Radio Station Search
While in FM mode, double press Volume + button or Volume - button two times to search a
next/previous FM channel.
Preset and store up to 6 FM radio stations
In FM radio mode, when a favorite station is found, double press Phone button to save, a beep
tone will sound. Preset and store up 6 FM radio stations. Once 6 stations have been saved, saving
a new station will overwrite the oldest saved station. Press Phone button to rotate between each
saved station.
9
7: Universal Pairing and Using
Power on other brand Bluetooth device into pairing suitable, meanwhile T30-S at standby mode,
press and hold button Intercom for 1 seconds, red and blue light flashing, then press button
Intercom ,the blue light flashing. After pair successful, the blue light slows down.
After paired, while T30-S at standby mode, press Volume+ and Volume- button at the same times,
T30-S reconnect with Bluetooth headset which connected before and start talking.
While in talking mode, short press Phone button to end it.
10
8: Bluetooth Intercom Talk
The T30-S can be paired with other T30-S for up to a total of 4 units for full duplex Bluetooth
intercom.
Pairing Two T30-S headsets and talk
Step 1: Power on unit 1 and unit 2, press and hold unit 1 and unit 2 Intercom Button for 1s, red
and blue light light flash alternately, then press Intercom button on either unit, the blue light
flashing. After pair successful, the blue light slows down.
Step 2: After pair finished, Short press Intercom button on either unit, it will start intercom.
During Intercom talking, short press Intercom button or Phone button to exit intercom mode.
11
Pairing Three T30-S headsets and talk
Step 1: Power on unit 1 and unit 2, press and hold unit 1 and unit 2 Intercom Button for 1s, red
and blue light light flash alternately, then press Intercom button on either unit, the blue light
flashing. After pair successful, the blue light slows down.
Step 2: Power on unit 2 and unit 3, press and hold unit 2 and unit 3 Intercom and Volume -
button for 1s, red and blue light light flash alternately, then press Intercom button on either unit,
the blue light flashing. After pair successful, the blue light slows down.
Step 3: After pair finished, Short press Intercom button on unit1 or unit2, it will start intercom
between unit1 and unit2.
12
Step 4: After pair finished, double press Intercom button on unit2 or unit3, it will start intercom
between unit2 and unit3.
During Intercom talking, short press Intercom button or Phone button to exit intercom mode.
Pairing Four T30-S headsets and talk
Step 1: Power on unit 1 and unit 2, press and hold unit 1 and unit 2 Intercom Button for 1s, red
and blue light light flash alternately, then press Intercom button on either unit, the blue light
flashing. After pair successful, the blue light slows down.
Step 2: Power on unit 2 and unit 3, press and hold unit 2 and unit 3 Intercom and Volume -
button for 1s, red and blue light light flash alternately, then press Intercom button on either unit,
the blue light flashing. After pair successful, the blue light slows down.
13
Step 3: Power on unit 3 and unit 4, press and hold unit 3 and unit 4 Intercom Button for 1s, red
and blue light light flash alternately, then press Intercom button on either unit, the blue light
flashing. After pair successful, the blue light slows down.
Step 4: After pair finished, Short press Intercom button on unit1 or unit2, it will start intercom
between unit1 and unit2.
Step 5: After pair finished, double press Intercom button on unit2 or unit3, it will start intercom
between unit2 and unit3.
Step 6: After pair finished, Short press Intercom button on unit3 or unit4, it will start intercom
between unit3 and unit4.
During Intercom talking, short press Intercom button or Phone button to exit intercom mode.
Clear internal intercom pairing record:
Press and hold Volume+ and Volume- button for 2s, red light flash 3 times, then Clear all internal
intercom pairing records.
14
9: Technical specifications：
1. Bluetooth 4.2 Support : HSP,HFP,A2DP,AVRCP, AGHSP
2. Working hours: 15 hours
3. Standby time: 300 hours
4. Charging time: 3 hours
5. Battery: lithium containing rechargeable lithium battery 650mAH, 3.7v
6. Dimensions: 43g
7. Weight: 85mm*40mm*26mm
8. Certification ：CE, FCC, TELEC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
15
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help Changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: this device may not cause harmful interference, and this device
must accept any interference received, including interference that may cause undesired operation.
Table of contents
