
QUICK INSTALLATION:
Using a Phillips head screwdriver,
loosen the cork padded mounting
clamps on each side until the clamps
are fully open. Insert the pickup into
the soundhole from the treble side
and grab the pickup with your other
hand on the bass side to position the
pickup into place. You want the pickup
to be as close to the neck as possible.
Center the logo under the strings.
Tighten the clamps gently until the
pickup is secure while leaving the
cable out of the soundhole.
CAUTION: Do not overtighten the
clamps as it may cause damage to the
pickup or the guitar.
Install the included clip around the
knurled portion of the barrel sleeve
on the endpin jack if you don’t want to
permanently install the jack into the
guitar. The clip can be used to attach
the jack to your belt or guitar strap
to relieve the cable from stress while
plugged in.
1.
2.