Molekule Air Mini User manual

Molekule Air Mini
User Manual

Try it in the bedroom.
Molekule Air Mini will work in any room, but giving it space in a central location,
and on a shelf, stand, or table will help maximize air intake. It’s designed for rooms
under 250 sq. ft. We recommend running it in the bedroom, closer to your bed for a
clean, sleep-breathing zone.
Run it 24/7.
Constantly clean air is a good thing, plus, your Molekule Air Mini is low energy.
So keep fresh air flowing.
01
Best Practices

Setting Up
02
Twist off shell and
pull out PECO-Filter.
Unwrap PECO-Filter
and place on base.
Align logo on shell with
arrow on base. Close shell
and twist to lock.
Unwind cord and
plug in.
Congratulations! You’re
all set up. Enjoy fresh air.

03
There’s just one button. It’s on top, in the center of the display. Tap it to wake the
device, and cycle through fan speeds. A long press of 3 seconds puts it on standby,
which deactivates the fan, UV-A lights, and display lights.
Controls & Interface
04
Modes & States
Fan Speeds
Your device’s five fan speeds correspond to the number of dotted white lights.
Tapping the button cycles through speeds.
Press here
Fan speeds
PECO-Filter status

PECO-Filter Status
The PECO-Filter status indicator helps you track the replacement schedule for your
PECO-Filter.
• Authentication
Each time you plug in your device or lock its shell into place, it checks the
authenticity of the PECO-Filter. A pulsing white light indicates it’s in progress. A
green light indicates it’s confirmed as a certified Molekule PECO-Filter and will
run normally. A red light indicates the PECO-Filter has not been verified and
the device will not start.
• Off
If the PECO-Filter Status Indicator is off, there’s no need to replace your
PECO-Filter.
• Orange
An orange light indicates your PECO-Filter is nearing recommended
replacement time.
• Red
A red light indicates your PECO-Filter has reached recommended
replacement time. Replace the existing PECO-Filter.
• Red & white flashing
Flashing red-and-white lights indicate your PECO-Filter should be replaced
immediately because it has exceeded its recommended replacement time. The
device will go on standby, the PECO-Filter Status indicator will flash red, and
the Fan Speed lights will pulse white as a reminder to replace. You can restart
Molekule Air Mini by tapping the center button on top of your device. Molekule
Air Mini will repeatedly go on standby after extended use until the PECO-Filter
is replaced.