Molnar SM300 User manual

T80124 — Rev.:29/01. 2018
Always keep this document!
Must be read before using your equioment!
3T. Scissor li
Fing of lighng set
(TRANSLATED VERSION)

T80124 — Rev.:29/01. 2018 2
1. Fit lighng modules on upper plates by means of pre-ed adhesive pads.
Note ! Upper plates must be cleaned and dry before axing. Pull cables from modules through holes in
upper plates.
Assemble cable from module with 2-core cable supplied by means of straight-through joints – use pliers
and aer that a heang gun or similar. Note ! Is is very important to keep the +/+ and -/- connecon in all
joints.
2. Fit cable trays on upper scissor arms
Lead cable down through cable protecons on scissor arms as shown.

T80124 — Rev.:29/01. 2018 3
3. Dismantle front cover for upright.
Fit transformer on back plate of upright as shown by means of M3x8 tapte screws.
4. Lead cables from lighng kit up along backside of upright.
Fit both cables on transformer by means crown socket as shown.
Connect 2-core cable from transformer to L1 and N (on secondary side of main switch) in control unit. If
necessary prolong cable from transformer. Fit crown socket on blue and white cables if dimmer is not installed.
Re-t front cover for upright.