Monessen Hearth MLDV500 - Winchester Installation instructions

PRODUCT SPECIFICATIONS
MLDV500 Winchester Direct Vent
42 1/2"
73"
1/2" OR 5/8"
22 1/4"
14 3/4"
32 1/2"
51 1/2"
36 1/2"
30 7/8"
20 5/8"
7 3/4"
22 1/4"
FRAMING DIM.
42 1/2"
FRAMING DIM.
22 5/16"
42 1/16"
6"
9 11/16"
34"
50 13/16"
3 1/8"
1"
2 1/2"
36"
41"
33"
27 5/16"
1 3/8"
14 1/2"
44 9/16"
38 3/4"
To avoid personal injury or property damage, the product described by this brochure must be installed, operated and maintained in strict compliance with the instructions packaged with the product and all applicable
building or fire codes.Contact local building or fire officials about restrictions and installation inspection requirements.All photographs and drawings on this brochure are for illustrative purposes only and are not intended
for, nor should they be used as a substitute for the instructions packaged with the unit.Appearance and specifications of the product are subject to change without notice.© 2007 Monessen Hearth Systems Co.
A Brand of Monessen Hearth Systems Co.
149 Cleveland Drive, Paris, Kentucky 40361
www.monessenhearth.com
GLASS VIEWING AREA
33”W x 25 13/16”H 902 Square Inches
TECHNICAL INFORMATION
Max. Btu Input: 34,000 BTU/HR
Ignition System: Standing Pilot or Signature Command™ System
GasType: Natural or LP
FlueType: Simpson Dura-Vent, Selkirk Metalbestos, MetalFab
Termination: Rear/TopVent Convertible
Clearance to Flue for Interior: 3"Top 1" Bottom and Sides
Clearance to Flue for OutsideWall: 1"
Clearance to Fireplace: 0"
MinimumVent Height Before Elbow: 12”
CSA Design Certified
FIELD INSTALLED ACCESSORIES
Louvers: Brass, Pewter
Firebrick: Cottage Clay or Cottage Red
VariableThermostat Controlled Dual ForcedAir Blower (160 cfm) – BLOTSDV
Mesh Glass Cover
AmbientTechnologies™Remote Controls andThermostats
HPBA
Hearth, Patio & Barbecue Association
MADE IN U.S.A.