The picture shows the default values for each item.
The bottom line (Info) shows specific values for your
machine’s video signals. NOTE: If the Info values show
00.00, there is no video signal. Again, verify that the
video cable is secured before you do anything else.
4. Size your video image.
Focus on the first five settings. Don’t worry
about brightness or contrast yet.
H POSITION (HORIZONTAL)
The default value is 00. The range is -99 to +99.
WIDTH
This is a very useful setting: use it to adjust the width
of the video on your screen. Use it as well to eliminate
vertical lines. The range is -99 to +99.
V POSITION (VERTICAL)
Defaults to 00. The range is 00 to +99.
HEIGHT
The height defaults to 00 and the range is 00 to +99.
PHASE
After you use the WIDTH setting, some vertical lines may
still be present. Use this setting to eliminate them entirely.
STYLE
RGB (A) is the default. If you are using this LCD as a
monochrome and want a black and white screen instead of
green, change the style to YUV. RGB (D) is also available.
