1•888•557•3848
Wards.com 7
6
How to Use How to Use (cont.)
WARNINGS:
• Before rst use, remove and disgard the 2 foam strips from the sides of the
vacuum and install the 2 side brushes on the bottom (see locations on page 5,
#3).
• DO NOT use this vacuum on long plush carpets or rugs (over ¼") or on dark-
color oors.
• Curtains, fringes, cords, papers, clothing or other objects may get caught up
in the wheels or brushes. Pick up these objects before operating the vacuum.
• DO NOT place anything on top of this vacuum or attach any object to it.
• Only use the original battery and charging dock. Other unmatched batteries
and chargers may cause electric shock, re or product damage.
• Fully charge the vacuum before rst use (may take up to 5 hours).
Charge
1. Connect the power cord to the charging dock.
2. Place the charging dock against a wall and remove obstacles from 1 yard on
each side and 2 yards from the front.
3. Plug the cord into an outlet. The green light on the dock will ash.
4. Place the vacuum onto the charging dock, aligning the charging poles. Charge
only with the dust box attached, never with the water tank.
5. Press POWER on the vacuum. POWER will light up on the vacuum and HOME
will ash on the vacuum. The HOME light will be solid green when fully charged.
Operate
1. For cleaning the whole house, press POWER on the vacuum or press AUTO
CLEAN on the remote once for a bow-shaped path. Press AUTO CLEAN again
to activate super suction.
2. Press MODE on the remote once to set the path to spot cleaning.
3. Press MODE on the remote again to change the path to single-room cleaning
and close all doors to the room. (This mode uses super suction automatically.)
When done, the vacuum will not be able to return to the charging dock unless
the dock is installed in this room.
4. Press MODE on the remote 3 times to select perimeter cleaning (the vacuum
will move around the edge of the room.
5. Manually change the path of the vacuum by pressing the directional buttons on
the remote control (forward, backward, right or left).
6. Press START/STOP on the remote or POWER on the vacuum to stop and start
the vacuum.
7. When done, the vacuum will automatically go back to the charging dock for
recharging (or press HOME on the remote).
Note: If stationary for more than 10 minutes (off the charging dock), the
vacuum will switch to sleep automatically. Press START/STOP on the
remote or POWER on the vacuum to restart.
Recharge
1. When the battery is low, press HOME on the remote control and the vacuum
will return to the charging dock (or you can pick up and place the vacuum onto
the dock).
2. When the vacuum is operating and the battery gets low, the vacuum will
automatically go back to the charging dock for recharging.
3. When not in use, turn off the vacuum to preserve the battery charge.
Set the Clock
1. Make sure the vacuum is on, then press CLOCK on the remote control.
2. The display will ash. Press FORWARD/BACKWARD arrows to set the hour.
3. Press LEFT/RIGHT arrows to change from hour to minutes.
4. Press FORWARD/BACKWARD arrows to set the minutes.
5. Press CLOCK to save the setting.
6. If the remote control batteries are changed, the clock will need resetting.
Schedule a Cleaning Plan
1. Make sure the vacuum is on, then press SCHEDULE on the remote control.
2. The display will ash. Press FORWARD/BACKWARD arrows to set the hour.
3. Press LEFT/RIGHT arrows to change from hour to minutes.
4. Press FORWARD/BACKWARD arrows to set the minutes.
5. Press SCHEDULE to save the setting.
6. To cancel the cleaning plan, reset to 00:00 and press SCHEDULE to save.
