montpellier CT200 User manual

Installation and Operating Instructions
MODEL: CT200/CT250
Built-In 2 Zone Ceramic Hob
Please read these instructions carefully before attempting to install or use this appliance.
It is advisable to keep these instructions in a safe place for future reference.
(Picture shown for indicative purposes only )

2
In
t
roduc
t
ion
Thank you for choosing this montpellier branded appliance. It
has been designed to give years of trouble-free use provided
it is installed and maintained correctly.
Please read these instructions carefully before installing or
using your appliance. It is advisable to keep your purchase
and
installation receipts with these instructions in a safe place for
future reference. Included is some important safety information
in addition to guidelines and recommendations that will enab
le
you to take full advantage of all the functions available.
T
his
quali
t
y
applian
c
e
has
been
t
e
st
ed
and
c
e
r
t
i
f
ied
t
o
m
e
e
t
all
applicable UK electrical and safety standards.
This appliance must be installed and connected in
accordance with current regulations.
After unpacking the appliance ensure that there is no visib
le
damage. If the appliance has been damaged during transit,
do not use it, contact your retailer immediately.

3
Your 2 year Manufacturer's guarantee
THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS.
Your new montpellier appliance carries a free guarantee which protects you against the cost of
repairs during the first 24 months from date of purchase provided that:
Any claim is accompanied by evidence of the model reference, model serial number and proof of
purchase, such as a Sales Receipt, showing that the appliance was purchased within the 24
months prior to the date of claim.
What is not covered under the Guarantee:
·Any appliance not correctly installed and operated in accordance with the
manufacturer's instructions.
·Any appliance that is used for anything other than domestic purposes.
·Any defect caused by accident, misuse, unauthorized modification or inexpert repair.
·Cost of Call-out where a fault cannot be found with the appliance.
·Cost of Call-out for work covering routine maintenance, such as, but not exclusively,
cleaning of filters or defrosting.
·Cost of Call-out for work required to correct the alignment of doors following door
reversal procedures carried out by you.
·Use of the appliance by anyone other than the Householder.
·Use in any commercial environment.
·Consumable items, such as, but not exclusively, fuses in plugs, bulbs and breakable
items which require routine replacement.
·Repair costs incurred that have not been authorised by Repairtech and/or carried
out by a non-approved Repairtech engineer.
YOUR GUARANTEE IS VALID ONLY IN THE UK.
To Register your Appliance simply complete the card in your appliance pack and return it with a
stamp affixed or Alternatively you can Register online at www.repairtechuk.com
SERVICE HELP-LINE
Should your appliance develop a fault, please call the
Repairtech Service Helpline on:
01527-888133
Please remember to have all your product details available, including the model number, serial
number, date of purchase and your retailers’details before registering a fault.
Your service call cannot progress without this information.

4
Description of the Appliance
1. Dual Cook Zone
2. Large Cook Zone
3. Touch Controls
(Picture shown is for indicative purposes only)
1.
2.
3.

5
CONTENTS:
Section 1. Installation
Section 2. Safety Advice
Section 3. Operating the Appliance
Section 4. Maintenance

6
Section 1. Installation
-Remove all packaging, protective film and securing tape from the appliance.
-Position the appliance in a dry atmosphere.
- The following dimensions are provided as a guide for installation –your installer will
carry out the installation in accordance with the current regulations.
- Your installer will connect the power cable in accordance with the current regulations.
To install this appliance, please proceed as follows:
1.1. Work-Surface Cut-Out & Position Near Walls
1.2. Securing the Hob
Apply the one sided self-adhesive sealing tape supplied all the way around the lower
edge of the cooking surface along the outer edge of the glass ceramic panel.
Now position the hob into the work surface cut-out to secure it into place.
Adjoining Walls
A(mm)
B(mm)
Combustible 60 150
Non-combustible 40 50

7
1.3. Electrical Connection
This appliance can be fitted with a 13 amp plug and plugged into a standard 13 amp
socket.
We recommend that this appliance is ‘hard wired’to a suitable fused point adjacent to
the appliance housing and protected with a 20 amp fuse. Please note that a
switchable spur should be accessible above the work surface to allow the power to
be turned off by the consumer.
Your installer will connect this appliance in accordance with current regulations.
The wires in the mains lead are coloured in accordance with the following code:
Brown = L (Live), Blue = N (Neutral), Green/Yellow = Earth
If not supplied with a fitted cable, you should connect the power supply to the
appliance as follows:

8
Section 2. Safety Advice
-Please read this booklet thoroughly before installing and switching on the
appliance. The manufacturer accepts no responsibility for incorrect
installation and usage.
-This appliance is guaranteed for Domestic Use Only.
-The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that they do not play with
the appliance.
-This appliance must only be used for cooking/heating foods and liquids.
Do not use it for any other purpose.
-If using an adaptor, this must be used in accordance with the
manufacturers instructions and ensure that the electrical circuit is not
overloaded as this could cause overheating.
-Do not twist or bend the cables, and keep them away from hot surfaces.
-Following installation make sure that the power cable is not trapped
underneath the appliance.
-Keep the appliance surfaces clean. Failure to do this could lead to the
appliance malfunctioning.
-The surface of this appliance will get hot during use. The surface of this
appliance will remain hot after it has been turned off. Do not touch or
clean the heating zone until it has completely cooled down.
-If the power supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.

9
Section 3. Operating the Appliance
3.1. Control Panel
3.2. Timer, Power and Cooking Functions
Switching the appliance on:
Switch the hob on by touching the ON/OFF key . All heater displays show a static
“0”and the bottom right dot will blink. If no cooking zone is selected within 10
seconds, the hob will automatically turn off.
Switching the appliance off:
Switch the appliance off at any time by touching .
Switching the cooking zones on:
Touch the heater selection key corresponding to the zone you wish to cook on. There
is a static dot indication of the selected heater display and a blinking dot on all other
displays.
Select the temperature by using the increase setting key or decrease setting
key . The heat selection buttons must be pressed within 3 seconds, or the heater
selection will be cancelled. The element is now ready to cook.
Dual-Oven
Zone Heater
Rear Heat
zone Heat Setting Child Lock
Front Heat Zone Heat Setting Timer On-Off

10
Switching the cooking zones off:
A cooking zone can be turned off in 3 different ways:
·Simultaneous operation of the and keys.
·Reducing the heat setting to “0”by operating key.
·Use of the timer turn off function.
If the cooking zone is hot, “H”will be displayed instead of “0”.
Dual Zone Function:
The dual zone function can be activated by selecting the Dual Zone Selector key. The
extension zone can only be activated after a heat level of 1-9 is selected.
Heat Boost Function:
All heat zones are equipped with a heat boost function.
If the heat boost function is active then the heat zone will operate with maximum
power for the period of the heat boost time. This is indicated through a flashing “A”,
alternating with the heat setting value on the heater display. Once the heat boost time
has ended only the heat setting will be shown.
If the heat boost is to be used for a heat zone, heat level 9 must be selected by
pressing starting from level 0. After this “A”should alternately be displayed. The
heat boost can be turned off by pressing until heat setting “0”appears. The heat
boost can be activated again by pressing if the heat setting is set to 9. The display
will flash “A/9”.
Operating Time Limitation:
Every cooking zone will be switched off after a defined maximum operation time if the
heat setting is not modified. Every change in the cooking zone resets the timer of the
safety switch off function. The maximum operation time depends on the selected
temperature level.
Sensor Safety Cut Off:
To prevent the appliance from unwanted, random sensor operation, a sensor monitor
is included. In case one or more buttons are held for longer than 12 seconds, the
appliance will make a sound and switch off. The safety turn off causes the display to
flash “F”on all heaters displays.
Over Temperature Switch Off:
As the control panel is located fairly near a heat zone it is possible for an incorrectly
placed pan to heat up the glass of the control panel and cause damage. If this area
gets too hot it will switch off automatically and be indicated on the heater display with
the letter “t”until the temperature decreases.

11
Child Lock:
After switching on the control, the child lock function can be activated. To activate the
child lock, simultaneously operate the increase heat setting key and decrease heat
setting key , and then operate the increase heat setting key again. “L”meaning
LOCKED will appear in all the heater displays and the control cannot be changed.
To deactivate the child lock, simultaneously operate the increase heat setting
key and decrease heat setting key , and then operate the decrease heat setting
key again. The ”L”symbol, meaning LOCKED should now have disappeared.
Key Lock:
When the Key Lock function is active it is only possible to switch the appliance off. If
the key lock button is pressed and held for two seconds the lock will be activated
and acknowledged by a buzzer. After this two second period the key lock indicator
will flash and the heater will be locked.
Timer function:
The timer function is available for the following situations:
Minute minder timer (1-99 min):
Touching the key once will activate the minute minder timer (no cooking zone
display will be flashing). “00”will appear indicated that the timer is active.
Touch to increase the time or touch to decrease the time. You can adjust the
timer between 0 and 99 minutes.
The sound signal will be stopped by operating any key.
Cooking zone timer (1-99 min):
When the hob is switched on, an independent timer can be programmed for every
cooking zone. To set a timer for a cooking zone you must touch the key. It is
important to remember that the first time this key is selected it will operate the minute
minder but by touching the key again it will then select an active cooking zone,
touching this key additional times will allow you to scroll through the active heater
zones indicated by the flashing Cooking Zone Indicator.
Touch to increase the time or touch to decrease the time. By touching
additional timers can be set and you can also toggle through your active timers.
All timers will be erased by switching off the appliance but the minute minder will
continue to operate.
To erase a timer you must toggle through the timers using the key until you have
found the correct one and then touch and decrease the time to “00”. Alternatively
you can touch and simultaneously until “00”is shown.
Touching any button will stop the timer alarm.

12
Section 4. Maintenance
Before any maintenance or cleaning work is carried out, DISCONNECT the
appliance from the ELECTRICITY supply and ensure that the appliance is
completely cool.
4.1. Cleaning the Hob Surface
Clean spillages from the hob surface as soon as possible after use. Always ensure
that the surface has cooled down before cleaning.
Use a soft cloth or kitchen paper to clean the surface. If the spillage has dried on the
surface you may need to use a specialist vitro-ceramic glass cleaner, available from
all good supermarkets.
Do not use other abrasive cleaners and/or wire wool etc as this may scratch the
surface of the hob.
4.2. What to do if something goes wrong
There is no power to the appliance:
-Check there is not a power cut
-Check there is power to the electric socket/appliance
After cooking the letter ‘H’is displayed:
-This is the hot surface indicator –it will remain on until the appropriate heat zone has
completely cooled down.
After switching off, the appliance sounds like it is still running:
- This is the cooling fan –it will remain on until the appliance has completely cooled
down.

13
If after the previous checks there is still a fault, please
contact the Repairtech Service Helpline below. Please
ensure that you have the model number, serial number,
date of purchase and retailers information available
before you make the call.
Should your appliance develop a fault, please call the
Repairtech Service Helpline on:
01527-888133

14
Important Note:
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product.
The
symbol on the product, or on the documents accompanying the
product, the Crossed Out Wheelie Bin, indicates that this appliance
may not be treated as household waste. Instead it shall be handed
over to the applicable collection point for the recycling of electrical
and electronic equipment.
Disposal
must be carried out in accordance with local
environmental regulations for waste disposal. For more detailed
information about treatment, recovery and recycling of this product,
please contact your local authority, your household waste disposal
service or the retailer where you purchased the product.
We continuously try to improve our products for the benefit of our customers.
For this reason we reserve the right to make changes to any product at any
time, without notice
Issue: 01/20-11-2014