Mood Media Aaron's Harmony User manual

MOOD+AARON’S
MOOD HARMONY™
MUSIC INSTALLATION GUIDE
Welcome to Mood Media.
This document contains the step-by-step instructions you will need to connect Mood’s Harmony
Music Player to your Aaron’s DJ System.
The complete installation should take no more than 30 minutes.
Included & Required
1. Harmony Player
2. A/C Power Adapter
3. RCA Cables
4. Remote Control
5. Batteries x 2
Included but
NOT Required
1. HDMI Cable
2. Data Cable (cat5)
Front
Showing your 3 status lights
(green when online)
Back
This is where you will connect
your RCA cable and power
adapter
STEP 1
+ The Harmony Music Player comes in a brown box with a lable
saying Audio.
+ Open the box & unpack all contents
STEP 2
+ Take a moment to check you have all the necessary parts.
2.
1.
3.
4.
5.
1.
2.
STEP 3
+ Familiarize yourself with the media player.
STEP 4
+ Bring all required parts to the Aaron’s DJ System
STEP 5
+ Locate the AUX Audio Input on the back of the DJ System
AThis is where your RCA cables
will be attached
B IMPORNTANT: DO NOT connect
the cables to the LINE OUT AUDIO
OUTPUT. They must be connected
to the AUX AUDIO INPUT
STEP 6
+ Connect the RCA Cables to the AUX Audio Input
AThe yellow connection is not
required
B Connect white-to-white and
red-to-red

STEP 7
+ Connect the RCA Cable to the AV input on the Harmony Music Device
STEP 8
+ Plug in the power cable to the outlet and connect it to the power input
on the Harmony Music Device
STEP 10
+ Selecting the correct input on the DJ System
STEP 9
+ Give the Harmony Music player about a minute to boot-up. A suc-
cessful wifi connection will be confirmend when you see the 3 LED
status lights illuminated in green.
1. Boot-up takes no more than 1
minute
2. 3x Green LED status lights
illuminated = Successful
connection to Aaron’s
instore wifi
1. Locate the input button on
the front of the DJ system
2. Click it until AUX is displayed
STEP 11
+ Turn up the volume on the DJ System
1. Increase to the appropriate
volume for your store
STEP 12
+ Use the Velcro to mount the Harmony Device to the back of the DJ
System
1. Make sure you don’t cover the serial
number on the botom of the device with the
Velcro
2. Attach the Harmony device to the back
of the DJ System’s headend unit (Not the
speakers) with cables facing downwards
and just above the RCA connections on the
DJ Systems