Moon Valley M-1000 User manual

1
M-1000 56” Round Table Assembly Instructions
PLEASE NOTE: Please check contents and read directions carefully before assembly. If any items are missing or damaged, do
not take the product back to the store. Call Moon Valley customer service at 313-766-4950 and we will correct the problem as
promptly and as efficiently as possible. Also, checking or cracking of the logs is a natural part of the drying aspect of cedar.
This does not affect the structural integrity of the wood. This natural occurrence enhances the rustic beauty of the product.
Section 2: Assembly of 56” Round Table Frame to Table Top
Step 6: Lay pre-assembled table top (A) upside down on a padded surface. Then secure the leg
(H) to the wing brace of pre-assembled table top (A) using 4” lag bolt (G). Use ¼” washer (W)
when fastening the lag bolt.
Step 7: Align and attach an 11” brace (F) to each side of each leg (H) securing it to the table
bottom, using 2 ½” lag bolts (I). Use ¼” washer (W) when fastening the lag bolt. A total of 8
braces.
C
E
H
A
Bottom
of Table
Wing
Brace
F
H

2
Step 8: Attach pre-assembled seat (B) to frame as shown (C). Align to back edge of the seat
(B) with the ends of the braces (C), and measure to center the seat as much as possible. Use 4”
lag bolts (G) through the pre-drilled holes in the braces (C) to secure. Use a ¼” washer (W)
when fastening the lag bolt. Note: Use a level to get the best alignment for the seat. Seats may
still appear crooked at this point. This should be corrected in the next step.
Step 9: Use a 20” brace (J) on each side of the table legs (H) to and attach it to the seat bottom
braces (B) (as shown). Use 2 ½” lag bolts (I) through pre-drilled holes in all 8 braces (J). Use
¼” washer (W) when fastening lag bolt. Place t-nut (Bb) with prongs facing down and tap into
pre-drilled hole on end of table leg. Screw leveler (Aa) into t-nut (Bb). Place table upright and
adjust metal leveling screws (Aa) as needed.
Thank you for choosing Moon Valley and we hope that
you enjoy your 56” Round Table. To view other Moon
Valley products, please contact your local dealer or visit
us at www.moonvalleycedarworks.com.
Moon Valley Cedar Works 12717 Marlin Drive, Redford, Mi
48239
Phone: [phone] Fax: [phone]
September 2012. Please do not let children play with plastic bag.
H
H
H
C
C
B
B
C
H
J
Aa

3
Moon Valley Furniture Care, Maintenance & Warranty Sheet
Stained Furniture
Moon Valley’s linseed oil-based stain has a uniform color consistency, seals out moisture, protects against
mildew and blocks the damaging effects of ultra-violet light. It also penetrates the wood in order to help
prevent discoloration. In order to maintain the stained items, it is recommended to wash and dry the areas
then re-apply a coat of stain. Moon Valley supplies their stain in quart cans which can be purchased from
your local dealer.
Varnished Furniture
Varnished Moon Valley furniture is dipped piece by piece in a sealer that provides uniform color
consistency, seals out moisture, protects against mildew and blocks the damaging effects of ultra-violet
light. It is then topped off with 2 coats of marine spar varnish for a glossy look. This varnish is specially
formulated for outdoor use and should be maintained once a year. To do this, lightly sand the item using a
medium-grit sandpaper (100 to 120-grit) or steel wool. Be sure that the surface is clean and completely dry
before beginning the process. Next, apply a coat of the new varnish, usually by brushing. Let dry as
needed and repeat again for extra protection against weathering. Moon Valley supplies their varnish in
quart cans which can be purchased from your local dealer.
Unfinished Furniture
Moon Valley products are made from white cedar. Cedar is naturally more resistant to weather decay and
insect damage than other types of wood, so you can simply leave it as is. Over time, it will turn a silvery-
gray color which gives it a rustic, aged look. However, there are finishing options such as using a water
sealer, varnish, stain, or paint based on customer preference. Before undertaking any of these options,
please refer to our website for suggested finishing steps.
Cracking or Checking of the Logs
You may notice some cracking or checking of the logs on your furniture, which is completely natural and
necessary for cedar left in log form. This does not compromise the integrity or strength of the product in
any way. Many times, it enhances the natural rustic beauty of the furniture. For more information on
cracking and checking, please visit our website (www.moonvalleyrustic.com).
Winter Storage
If it is not possible for you to store the furniture indoors for the winter, simply stand or lean your picnic
table (preferably on blocks) against your house or garage. This will help lessen the effects of weathering
by not allowing snow or water to accumulate on the flat surfaces of the furniture. Do not cover with plastic
or place the table upside down on the ground, as this will trap moisture against surfaces and cause damage.
If you choose to cover the furniture, be sure that the cover is breathable and allows for proper air
ventilation.
Safety
Although your furniture has been constructed for greater strength and stability, it should be checked
periodically for looseness or wear. Regularly inspect joints, bolts, and hooks and hardware if necessary.
These items can purchased from your local dealer, or by using the below contact information.
Thank you for purchasing a Moon Valley product. We have made every effort to ensure that you are
satisfied with your selection. To insure prompt and correct handling of any errors, missing parts, or to
answer any questions, please call [phone]. All replacement part orders will be filled as quickly as
possible.
Limited Warranty
Moon Valley warrants its products to be free from manufacturing defects for a period of one year after its
purchase. Proof of purchase must be provided. Finish is not included under the limited warranty. Any
defects must be promptly reported to Moon Valley and the defective part will be replaced without charge.
Disclaimer of Warranties
This limited warranty is made in lieu of all other warranties, express or implied, including implied
warranties of merchantability and/or fitness for a particular purpose.

4
Limitation of Liability
Moon Valley liability is limited to the replacement of defective parts, as set forth in its limited warranty.
Moon Valley shall not be liable for any incidental or consequential damage, including without limitation,
damages for personal injury, death, or loss of profits.
Do not let children play with plastic bags