THANK YOU!
For purchasing a Morley® pedal.
Please take a few minutes to familiarize yourself with the
features of your new pedal. With common sense handling,
it should last for years. We know you will appreciate the
rugged construction of your Morley®. Most of all, we hope
you enjoy using it as much as we enjoyed building it.
CONTROLS
The Emerald Echo has three controls: REPEAT, MIX &
DELAY. Understanding these controls will help you to get
the sound you are looking for.
The REPEAT control adjusts the amount of repeats the
echo will reproduce when a note is hit. The amount ranges
from one repeat to multiple repeats.
The MIX control adjusts the mix of original signal and
effected signal. Refer to the sample settings section of this
manual for hints. Keep in mind that your overall sound is a
product of your guitar, amp, pickups, effects, cables,
strings and of course - playing style.
The DELAY control adjusts the amount of delay time from
0 to 300 milliseconds.
CONNECTIONS
IN: Input jack. Plug instrument into this jack using 1/4”
guitar cable.
OUT: Connect amplifier to this jack using a 1/4” guitar
cable.
9V: Connect Morley’s 9 volt 300 milliamp regulated AC
adapter to this jack.
NOTE: You’ll find your cord fits very tightly into our input
and output jacks. The tight fits helps prevent the cord from
becoming accidentally unplugged from the pedal. Make
sure the cords are completely plugged in for best results.
AC ADAPTER
Use only Morley’s 9-volt 300 milliamp regulated adapters.
Using a non-regulated adapter could cause a low
frequency hum in your amplifier.
BATTERY
The EMERALD ECHO is designed to use one 9 volt battery
when not using an adapter. We suggest you use a good
quality alkaline battery.
Your pedal is designed for long battery life. To prolong
battery life, unplug your cord completely from the input
jack when not using the pedal. When the pedal is not used
for extended periods, we recommend you remove the
battery from the pedal or replace it every six month to
prevent leakage problems.
BATTERY REPLACEMENT
When the battery becomes weak, the overall delay effect
will become weak and your signal may become slightly
distorted.
Remove the battery door located on the bottom of the
pedal. (a short cord is attached to the door to help prevent
loss. Once the door is off, the old battery can be removed
from the battery snap and a new battery plugged in. Make
sure the polarity (+/-) is correct before inserting the new
battery.
When you replace the battery door , you will notice it fits
very tightly against the battery. This prevents the battery
from rattling inside the pedal.
WARRANTY
All Morley® pedals are warranted for two years from date
of purchase. To obtain warranty service call
1-800-639-4668.
SPECIFICATIONS
POWER: 9 Volt Battery
CURRENT DRAW: 11 mA @ 9 VDC
WEIGHT: 1.2 lb./ .55 kg
INDICATOR: Echo effect on or Bypassed
185 Detroit Street, Cary, IL 60013
Phone:(847) 639-4646
Fax: (847) 639-4723
www.morleypedals.com
