Morphy Richards SpillMaster User manual

wwwwww..mmoorrpphhyyrriicchhaarrddss..ccoomm
SpillMaster
Please read and keep these instructions
VC70330 MUK Rev 1
For replacement parts, help with using your Morphy Richards product,
problems and lots more, contact us by phone or through our website.
UUKKHHeellpplliinnee::0088444488771100994499
RReeppllaacceemmeennttPPaarrttss::0088444488773300771155
IIrreellaannddHHeellpplliinnee::11880000440099111199
Use
This product is intended for picking-up liquids only. Picking up solid objects may cause
blockages in the nozzle. If blockages occur, please detach and clean the SpillMaster as directed.
Do not cover the bleed holes when holding the attachment, otherwise there may be a risk of the
cleaner overheating.
The SpillMaster must be attached securely and firmly to the vacuum cleaner hose or hose
handle. It may be necessary to use one of the attachment adaptors, supplied.
Safety devices
If the unit is tipped over in use, safety valves will operate to prevent water escaping, no pick-up
will be possible once these valves have operated. The valves will remain closed until the unit is
returned to it’s correct upright position and the suction is switched off. Similarly, if the unit is
overfilled, a float valve will operate, preventing any further pick-up. The suction must be
switched off and the tank emptied before re-use.
Filter
Regularly remove, clean and dry the filter.
Cleaning
Empty and rinse the product with clean lukewarm water after every use. Leave to dry upside
down for at least 24 hours or until completely dry before re-assembling the top unit to the tank.
Do not place in or near heating appliances to dry.
Getting the best from your new attachment...
70330 rev1 19/6/08 10:15 Page 1

22
IMPORTANT SAFETY
INSTRUCTIONS
The use of any electrical
appliance or attachment
requires the following common
sense safety rules.
Primarily there is danger of
injury or death and secondly the
danger of damage to the
appliance.
Please read these instructions
before using the attachment.
Location
• This appliance is intended for
domestic use only. Misuse or
use for commercial or any other
purpose will render the
guarantee invalid.
• Do not use or keep this product
outside.
• Do not store the appliance near
hot surfaces, eg. ovens or
heating appliances.
Personal safety
• Do not touch the cleaner, cable
or plug with wet hands.
• This product is not intended for
use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or lack of experience and
knowledge, unless they have
been given supervision or
instruction concerning the use
of the product by a person
responsible for their safety.
• Children should be supervised
to ensure that they do not play
with the appliance or
attachment.
Product safety
• Do not modify the product in
any way.
• Use only as described in these
instructions.
• Never attempt to pick-up solids.
The SpillMaster is only designed
to pick up liquids.
• Never pick-up inflammable
liquids such as spirits.
• Never pick-up strong alkaline or
acidic liquids such as bleach.
• Never pick-up volatile material
such as copier toner.
• Never pick-up hazardous
materials such as asbestos
dust.
• Never pick-up very hot liquids
such as boiling water.
• Never pick-up hot substances
such as hot ashes.
• Keep the liquid away from the
vacuum cleaner and the cleaner
cable and plug.
• Ensure that the plug of the
vacuum cleaner is removed from
the socket outlet before cleaning
or maintaining the appliance.
UUKKHHeellpplliinnee0088444488771100994499RReeppllaacceemmeennttPPaarrttss0088444488773300771155IIrreellaannddHHeellpplliinnee11880000440099111199
70330 rev1 19/6/08 10:15 Page 2

FEATURES
⁄Filter
¤Hose / hose inlet
‹Bleed holes
›Filter release buttons
fiTop unit
flTip-back safety device
‡Nozzle
·Water tank release button
‚Tip-sideways safety device
„Water tank
‰Max fill line
ÂFloat safety device
ÊHose inlet adaptors
(up to 4 sizes, dependent
on model)
fl
„
Â
33
wwwwww..mmoorrpphhyyrriicchhaarrddss..ccoomm
·
⁄
¤‹
fi
‡
‰
‚
Ê Ê
Dependent Dependent
on model on model
›⁄
›
70330 rev1 19/6/08 10:15 Page 3

44
ASSEMBLY
Assembling the
SpillMaster A
The SpillMaster may arrive in
two parts.
To assemble the product, align
the arrows on the water tank
with the arrows on the top unit.
Push the two parts together and
rotate clockwise until the top
part clicks into place.
OPERATING THE
SPILLMASTER
Depending on your model of
cleaner, your SpillMaster may
require an adaptor.
If required, choose the
appropriate adaptor and fit as
shown B.
Attaching the
SpillMaster to you
vacuum cleaner
Assemble the vacuum cleaner
according to it’s instruction
booklet.
Ensure the vacuum cleaner is
switched off before attaching
the SpillMaster.
Attach the SpillMaster directly
onto the vacuum hose with
adaptor if required C.
It is not recommended to use
any extension tubes when using
the SpillMaster.
USING THE
SPILLMASTER
Turn the vacuum cleaner on.
Place the SpillMaster on the
floor and tilt forwards so the
nozzle touches the floor D.
You are now ready to pick up
any liquid spills.
The SpillMaster can be used on
all floor types but must only be
used for liquid spills. It has not
been designed to suck up
solids.
For maximum effectiveness, use
the SpillMaster in a steady, slow
motion, pulling it towards
yourself. Always ensure the
SpillMaster is tilted forwards E.
Ensure only the nozzle touches
the floor, so the water tank is
not dragged through the liquid
spill.
Backward strokes are more
effective on deeper carpets.
B
UUKKHHeellpplliinnee0088444488771100994499RReeppllaacceemmeennttPPaarrttss0088444488773300771155IIrreellaannddHHeellpplliinnee11880000440099111199
A
C
D
E
70330 rev1 19/6/08 10:15 Page 4

55
wwwwww..mmoorrpphhyyrriicchhaarrddss..ccoomm
SAFETY FEATURES
As well as the hose filter, there
are three other main safety
features F which will cut off
suction to the SpillMaster in the
event of improper use:
If the SpillMaster is tilted
backwards, a slug in the nozzle
suction chamber will slide
backwards, blocking the suction
to the hose G.
If the SpillMaster is tilted
sidewards, a slug in the suction
chamber connecting to the
liquid tank will slide upwards,
blocking the suction in the unit
G.
If the SpillMaster is overfilled
with liquid, a float in the liquid
tank will rise upwards, blocking
the suction in the unit.
If any of the above occurs, turn
off your vacuum cleaner
immediately, empty the tank,
reassemble the SpillMaster and
resume use as described in
‘Using the SpillMaster’ section.
EMPTYING THE
SPILLMASTER
Ensure the vacuum cleaner
power is switched off.
Remove the vacuum hose from
the SpillMaster.
Take the SpillMaster to a sink or
drain to empty.
Press down on the tank release
button with one finger H.
With the other hand, rotate the
handle section anti-clockwise as
far as possible H.
Pull upwards to separate the
unit into it’s two parts.
Empty the contents of the
reservoir by tipping it upside
down over a sink or drain I.
F
Before safety
features activate
Safety features
activated
H
I
G
70330 rev1 19/6/08 10:15 Page 5

66
CLEANING THE
SPILLMASTER
It is recommended that the
SpillMaster is regularly cleaned
to prevent any build up of
residue.
Remove the filter by squeezing
the two white areas with a finger
and thumb and pull the white
tab until the filter is clear of the
product J.
Separate the SpillMaster into it’s
two parts as described in the
‘Emptying the SpillMaster’
section.
Empty the contents of the base
unit over a sink and then rinse
the reservoir with lukewarm
water to remove any residue.
Leave to dry upside down for at
least 24 hours or until
completely dry K.
HINTS & TIPS
(also see ‘Safety Features’)
• The SpillMaster can be used on
all floor types but must only be
used for liquid spills.
• It has not been designed to
suck up solids. If any solids
have accidentally been sucked
up, follow the advice in the
‘Cleaning’ section.
• Hold the SpillMaster ensuring
the bleed holes are not
obstructed L. If the bleed holes
are covered, this could result in
your vacuum cleaner over
heating.
• Do not attempt to overfill past
the max fill line. If overfilled, the
float safety cut-out will be
activated and the suction will
cease.
• If the float is activated, switch
the vacuum cleaner off and
empty the reservoir. The float will
drop back into it’s original
position.
• After use, empty the contents of
the water tank, clean and dry
the product fully.
• Regularly check that the filter is
not blocked, dirty or damp. If
the filter becomes dirty, rinse in
lukewarm water and leave to dry
fully before re-use.
• If the filter becomes damaged, it
must be replaced. Call our
helpline for replacement parts.
• When carrying the SpillMaster
to the sink, ensure it is kept
horizontal to prevent any
spillage.
PRODUCT STORAGE
• When finished, do not store
near any heat sources.
• Store in an upright, flat position.
• Only store when dry.
HELPLINE
If you have any difficulty with
your appliance, do not hesitate
to call us.
We are more likely to be able
to help than the store from
where you bought it.
Please have the following
information ready to enable our
staff to deal with your query
quickly.
• Name of the product
• Model number as shown on the
underside of the appliance.
• Serial number as shown on
underside of the appliance.
UK Helpline 0844 871 0949
Replacement Parts 0844 873 0715
Ireland Helpline 1800 409 119
UUKKHHeellpplliinnee0088444488771100994499RReeppllaacceemmeennttPPaarrttss0088444488773300771155IIrreellaannddHHeellpplliinnee11880000440099111199
L
J
K
70330 rev1 19/6/08 10:15 Page 6

77
wwwwww..mmoorrpphhyyrriicchhaarrddss..ccoomm
YOUR TWO YEAR
GUARANTEE
It is important to retain the
retailer’s receipt as proof of
purchase. Staple your receipt to
this back cover for future
reference.
Please quote the following
information if the product
develops a fault. These numbers
can be found on the base of the
product.
Model no.
Serial no.
All Morphy Richards products
are individually tested before
leaving the factory. In the unlikely
event of any appliance proving
to be faulty within 28 days of
purchase, it should be returned
to the place of purchase for it to
be replaced.
If the fault develops after 28
days and within 24 months of
original purchase, you should
contact the Helpline number
quoting Model number and
Serial number on the product, or
write to Morphy Richards at the
address shown.
You may be asked to return a
copy of proof of purchase.
Subject to the exclusions set out
below (see Exclusions), the
faulty appliance will then be
repaired or replaced and
dispatched usually within 7
working days of receipt.
If you suspect a fault, follow the
simple checks detailed below
before retrying the appliance or
calling the helpline.
• Check for blockages.
• Check the safety devices have
not operated.
If, for any reason, this item is
replaced during the 2 year
guarantee period, the guarantee
on the new item will be
calculated from the original
purchase date. Therefore, it is
vital to retain your original till
receipt or invoice to indicate the
date of initial purchase.
To qualify for the 2 year
guarantee, the appliance must
have been used according to the
instructions supplied.
EXCLUSIONS
Morphy Richards shall not be
liable to replace or repair the
goods under the terms of the
guarantee where:
1The fault has been caused or is
attributable to accidental use,
misuse, negligent use or used
contrary to the manufacturer’s
recommendations or where the
fault has been caused by power
surges or damage caused in
transit.
2The appliance has been used on
a voltage supply other than that
stamped on the products.
3Repairs have been attempted by
persons other than our service
staff (or authorised dealer).
4The appliance has been used for
hire purposes or non domestic
use.
5The appliance is second hand.
6Morphy Richards are not liable
to carry out any type of servicing
work under the guarantee.
7The guarantee excludes
consumables such as filters.
• This guarantee does not confer
any rights other than those
expressly set out above and
does not cover any claims for
consequential loss or damage.
This guarantee is offered as an
additional benefit and does not
affect your statutory rights as a
consumer.
• This guarantee is valid in the UK
and Ireland only.
70330 rev1 19/6/08 10:15 Page 7

88
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and
design. The company, therefore reserves the right to change the specification of
it’s models at any time.
The After Sales Division
Morphy Richards Ltd
Mexborough, SouthYorkshire,
England, S64 8AJ
Helplines (office hours)
UK 0844 871 0949
Spare Parts 0844 873 0715
Republic of Ireland 1800 409 119
VC70330 MUK Rev 1 06/08
FFoorrddeettaaiillssooffootthheerrpprroodduuccttssiinntthheeMMoorrpphhyyRRiicchhaarrddssrraannggee,,pplleeaasseesseeeeoouurrwweebbssiittee......
wwwwww..mmoorrpphhyyrriicchhaarrddss..ccoomm
For electrical products sold within the European
Community. At the end of the electrical products
useful life, it should not be disposed of with
household waste.
Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice in your country.
70330 rev1 19/6/08 10:15 Page 8