Morris and Alexander AL08-3 User manual

AL08-3 & AL08-4 Alexander Square Cup Attachment
for use with Chairs, Armchairs, Settees & Beds
Fitting & User Instructions
Long Hand Wheel (x4)
Leg/Castor Protector (x4)
Raiser Cup (x4)
Height fixing
Plastic Nut (x4)
Frame Assembly
Short Hand Wheel (x2)
Height Fixing Screw (x4)
These instructions apply to chairs, settees and beds. The raiser must be fitted from front to back for chairs & settees
and width ways (across the head and foot) of a bed.
Max Weight Loading - 635kg (100 stone) per pair. Each extra frame used allows an extra 317kg (50 stone) of weight
loading.
Please read these instructions carefully before installation.
User precautions:
• This product is only to be installed for the purpose for which it is intended (for raising chairs, armchairs, settees &
beds).
• Ensure that the raised furniture is stable before use.
• This raiser is for indoor use only.
• Check tightness of hand wheels and fixings periodically.
• Clean with a damp cloth. Use non-abrasive detergent and dry thoroughly.
• For larger p ieces of furniture you may require EXT-B2 Extender Bars to safely span the furniture.
Notes:
• CHAIRS/SETTEES - Extra stability can be achieved by raising the rear of the furniture higher than the front.
IDENTIFICATION OF PARTS (QUANTITY PER PAIR)
Morris and Alexander Ltd, Wymans Way, Fakenham Industrial Estate, Fakenham, Norfolk, NR21 8NT
Tel: [phone] Fax: [phone]. www.morrisandalexander.com. Certified to ISO 9001
Chair, Settee and Bed Raising Specialists
Issue 1

3
1Adjust raiser height before fitting. Secure height adjustment using screw & plastic nut.
2a b
ADJUST LENGTH
TO SUIT
a b
Tighten all long hand wheels to clamp the legs in place (fig 3a). Tighten short hand wheels on side of raisers to lock the
raiser's length (fig 3b). Finally, ensure the furniture is stable before use.
PROTECTOR CAP
TIGHTENED AGAINST Leg
Fit one raiser at a time. If the furniture has inverted shaped pyramid feet which are too steep to effectively clamp to,
secure the leg using wood screws (not supplied) through the holes located in the base of the square cup (fig 1). Do not
screw into plastic legs.