Mould King 16040 User manual

Mould King 16040 Magic Book Store

MouldKing 16040 Lighting Kits Installation Instruction
2. The cables should be set around the studs.(Shown as below)
1. The cable should be placed between or under bricks.
Note:
be overheated and damaged
insert, do not insert it forcefully, otherwise the pins of the socket will be bent or the socket will
exposed wires should face the welded "=" symbol(As Shown below). If the plug is hard to
3. Please pay attention to the direction of the wire socket: the side of the socket with
Please read this instruction before building, the ligthing kits should be installed during building.

Lighting Kitsinstalled inStep 82
Take outa warm light strip
as shown in the red box below
Start to paste the warm light strip
outcable the arrow
Warn light strip pasted, pull Cover the bricks

Light Kits installed in Step 156
Light Kits installed in Step 156
cable and a warm light socket
Take out a 350mm dual connector
plate as shown
Fixthesocket on the bottom
Put on the roof, the cable
shoud be pulled out as shown
Light kits installed in Step 490
Take out another warm light strip

Start to paste the warm light strip as
shown in the red box below
Warm light strip pasted as shown
Arrange the cables as shown Cover thebricks
Start to paste the warm light
strip as shown in the red box
below

Light kits installed in Step 493
Take another warm light strip Paste the warm light strip on
the bottom plate as shown
Take out a battery box and a
6-port socket, link them
Link tge cables with the sockets

Light kits installed in Step 565
Openthe roofcover as shown Putthe sockets and the
cablesinto the roof
Place the battery box here
Have a Great Time!