MOVETEC MCB-TC-4 User manual

MCB-TC-4/6 User Guide
Version : E
Release Date : 08/21/2018
P. 1
Dear User,
You have chosen a Movetec Synchronised System for your Actuators/Lifting Columns.
We will step by step follow you to a succesfull connection of your new Synchronised Actuator/Lifting Column
System.
This Instruction will be the same for both Movetec MCB-TC-4 Controlbox System and MCB-TC-6 Controlbox
System.

MCB-TC-4/6 User Guide
Version : E
Release Date : 08/21/2018
P. 2
Connection of Cables:
Step 1.
Please connect the Cascading Cable in the RJ45/Handset socket in the Movetec MCB-TC-4/6 Controlbox System

MCB-TC-4/6 User Guide
Version : E
Release Date : 08/21/2018
P. 3
Step 2.
Please connect the Motorcables in the Movetec MCB-TC-4/6 Controlbox System.
Step 3.
Please connect the Handset in the end of the Cascading Cable.
Step 4.
Please take the Handset and make a RESET by pressing both the buttons up/down in 3 sec.
Now you are ready to use the system.

MCB-TC-4/6 User Guide
Version : E
Release Date : 08/21/2018
P. 4
IF you have trouble connecting the System or the
System does not run as anticipated, please read
following:
n If after the RESET you can not move the Actuators/Lifting Columns, please make a
Complete New RESET.
n If the System also not move after the 2nd RESET, please check all the cables are connected
correct.
n Call Movetec HQ in Denmark [phone] or mail to [e-mail]