MP Lighting LED92 User manual

t 1.877.708.1184 f 604.708.1185 www.mplighting.com
16 West 4th Avenue, Vancouver BC V5Y 1G3, Canada Copyright © MP Lighting. All technical information in this document is subject to change. 06-2011
11/2 to 3/8” (13 to 10mm)
of hex bolt screws should
remain above finished
concrete when positioning
mounting plate.
2Attach conduit.
Clean using a soft cloth.
Maintenance
• Allen key
Tools
included
Parts Qty.
• LED unit
• Hex countersunk screw
• 1/4” x 3” Hex bolt screw
• 1/4” Hex cap nut
• RST waterproof connectors
• Conduit strain
relief connector
1
4
4
4
1
not
included
• Mounting plate 1
• Washers 4
114mm
4-1/2”
114mm
4-1/2”
915mm
36”
13 - 10mm
1/2 - 3/8”
114mm
4-1/2”
114mm
4-1/2”
915mm
36”
13 - 10mm
1/2 - 3/8”
3Pull cabtire cable so
approximately 36”
(915mm) of cable
remains above
concrete.
Rough In
LED92
Installation
Instructions
Cabtire
Cable
• Read all instructions.
• WARNING: RISK OF FIRE OR
ELECTRICAL SHOCK: Do not
make or alter any openings in the
compartment of wiring or electrical
components during installation.
Do not alter or add ballasts, or any
other electrical components.
• Installation and use of this fixture
mounting assembly requires a
person familiar with the construction
and operation of luminaire electrical
systems and the hazards involved,
if not qualified, do not attempt
installation.
• Turn off power before installation.
• Connect to 700mA constant current
driver only.
• Avoid using detergents
with hand softeners, anti-bacterial
agents, glass cleaners or acrylic
cleaning products.
• KEEP THESE INSTALLATION
INSTRUCTIONS.
CAUTION

t 1.877.708.1184 f 604.708.1185 www.mplighting.com
16 West 4th Avenue, Vancouver BC V5Y 1G3, Canada Copyright © MP Lighting. All technical information in this document is subject to change. 06-2011
1
4
Remove side cover
plate on fixture.
Reconnect both halves
of waterproof connector.
Separate RST
waterproof connectors
and connect wires.
5
2Pull cabtire cable
through base plate.
3Remove protective
sleeves from studs
and fasten base to
mounting studs.
Replace cover plate and
mount fixture head by
tightening hex screws with
Allen key.
6
Black
Locking
Tabs
Grey
Locking Tab
Black
Locking Tabs
Separate RST connectors by
depressing grey locking tab
and pulling apart.
Next open connector half
way by depressing two black
locking tabs.
Connect line, neutral and
ground wires to screw terminals
then tighten gland nut firmly.
RST Connector Instructions
•
•
•
Cabtire Cable
Cabtire Cable
Fixture
LED92
Installation
Instructions