Mr. Coffee BVMC-SC Series User manual

User Manual / Manual del Usuario
mrcoffee.com
SINGLE CUP
BREW
™
SINGLE SERVE 1.0 / CAFETERA INDIVIDUAL
BVMC-SC SERIES
OUNCE

2
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed to
reduce the risk of fire, electric shock, and/or injury to persons, including the following:
1. Read all instructions before using.
2. Do not touch hot surfaces. Use handles and knobs when available. Scalding may
occur if the coffee brewer is moved or opened or K-Cup®Pack is disturbed during
brewing cycles.
3. This appliance must be properly installed and located in accordance with these
instructions before it is used.
4. The use of accessory attachments not recommended by the appliance manufacturer
may result in fire, electrical shock or injury to persons.
5. Do not place on or near a hot gas or electric burner, or in a heated oven.
6. Do not use outdoors.
7. To protect against electric shock, do not immerse the cord, plug or the appliance in
water or any other liquid.
8. Use only water in this appliance! Do not put any other liquids or foods in the Water
Reservoir.
9. Turn off and unplug the coffee brewer when not in use and before cleaning. Allow to
cool before attaching or removing parts and before cleaning the appliance.
10. Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions or is damaged in any manner. Contact your Mr. CoffeeTM Customer
Service to arrange for replacement or repair.
11. Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
12. Close supervision is necessary when any appliance is used by or near children.
13. Do not open the brewer while brewing is in progress. Keep reservoir lid closed during
brew cycle.
14. Do not use appliance for other than intended use.
15. Place the appliance on a hard, flat, level surface to avoid interruption of airflow underneath.
16. Do not brew without K-Cup®holder full installed.
17.There are two sharp needles that puncture the K-Cup®pack, one above the K-Cup®
Pack Holder and the other in the bottom of the K-Cup®Pack Holder. To avoid risk of
injury, do not put your fingers in the K-Cup®Pack Assembly Housing.

3
SAVE THESE INSTRUCTIONS
Please read ALL of the instructions in this manual carefully
before you begin to use this appliance. Proper care and maintenance will ensure a
long life and a trouble-free operation for this appliance. Please save these instructions
and refer to them for cleaning and care tips.

4
THIS PRODUCT IS FOR
HOUSEHOLD USE ONLY
POWER CORD INSTRUCTIONS
1. A short power supply cord is provided to reduce the hazards resulting from a person or
pet becoming entangled in, or tripping over, a longer cord.
2. An extension cord may be purchased and used if care is exercised in its use.
3. If an extension cord is used, the marked electrical rating of the extension cord must be at
least as great as the electrical rating of the appliance. The resulting extended cord must
be arranged so that it will not drape over a countertop or tabletop where it can be pulled
on by children or tripped over accidentally.
4. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk
of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do
not modify the plug in any way.

5
Welcome & Congratulations
on the purchase of your new Mr. Coffee®
Single Serve 1.0. Your new brewer will wake up
with you in the morning and provide you breaks
and treats during your hectic daily activities.
How you enjoy your Mr. Coffee®
Single Serve 1.0 is up to you!
TM
TABLE OF CONTENTS
Important Safeguards........................................................ 2
Special Cord Set Instructions ........................................... 4
Parts Diagram..................................................................... 6
Set-Up & How to Brew...................................................... 7
Helpful Hints .................................................................... 11
Cleaning and Maintaining .............................................. 12
Troubleshooting ............................................................... 15
Service and Maintenance ............................................... 16
Warranty Information....................................................... 17

6
1. BREW / OFF
2. DRIP TRAY PLATE
3. DRIP TRAY
PARTS DIAGRAM
7
5
1
8
4
6
9
2
3
4. PULL HANDLE & INSERT
K-CUP® PACK
5. K-CUP® HOLDER
6. K-CUP® HOLDER LID
7. WATER RESERVOIR
8. LOOSE GROUND FILTER
9. PRESS TAB

7
1. Place Brewer upright
on a flat surface,
remove protective
sheet and plug into
outlet.
2. DO NOT remove or
puncture the foil lid of
the K-Cup®Pack.
Ensure you are using
the K-Cup®Pack
Holder.
3. Press tab and pull
K-Cup® Holder forward.
SET-UP & HOW TO BREW WITH K-CUPS
CAUTION:
• There are two sharp
needles that puncture
the K-Cup®Pack, one
above the K-Cup®
Pack Holder and the
other in the bottom
of the K-Cup®Pack
Holder. To avoid risk
of injury, do not put
your fingers in the
K-Cup®Pack Housing
Assembly.
• Do not remove K-Cup®
holder during the brew
cycle.
• Do not open reservoir
lid during the brew
cycle.
4. Lift and open the top
of the K-Cup®Holder.
5. Place K-Cup®inside
of K-Cup®Holder and
close K-Cup®Holder
Lid.
6. Push K-Cup®Holder
back into place. The
locking tab will snap to
lock it in place.

8
9. Place a coffee cup or
travel mug (up to 10oz)
in the dispense area on
the drip tray. Press the
BREW button.
10. When the water
reaches the perfect
brewing temperature,
the brewing will
begin.
11. Enjoy!
NOTES:
A. Drip Tray can
be removed to
accommodate larger
mugs.
B. It is normal to hear
gurgling noises from
the Water Reservoir, it
is part of how this unit
operates.
C. Pump will remain on
for up to 90 seconds
to complete brewing
and drying the K-Cup®
Pack.
7. Lift lid to the Water
Reservoir and fill with
filtered or bottled water
up to the desired fill
level without exceeding
the MAX fill line.
8. Close the Water
Reservoir Lid.
NOTES:
A. Always brew with
Reservoir Lid closed.
B. Unit will brew out
all water added to
reservoir. Ensure
the cup or mug can
contain all the liquid
added to reservoir.
C. Any liquid overflow
from your cup will be
collected by the drip
tray to keep brew
space neat and clean.

9
1. Place Brewer upright
on a flat surface,
remove protective
sheet and plug into
outlet.
2. Fill the Reusable Filter
with your choice of
ground coffee to the
max fill line.
3. Press tab and pull
K-Cup® holder forward.
HOW TO BREW WITH REUSABLE FILTER
4. Lift and open the top of
the K-Cup®Holder.
5. Place Reusable Filter
inside of K-Cup®Holder
and close K-Cup®
Holder Lid.
6. Push K-Cup®Holder
back into place. The
locking tab will snap to
lock it in place.
NOTE: Make sure the
edge of the filter is free
and clear of any particles
to avoid leaking.
CAUTION:
• There are two sharp needles that
puncture the K-Cup
®
Pack, one
above the K-Cup
®
Pack Holder
and the other in the bottom of
the K-Cup
®
Pack Holder. To
avoid risk of injury, do not put
your fingers in the K-Cup
®
Pack
Housing Assembly.
• Do not remove K-Cup
®
holder during the brew cycle.
• Do not open reservoir lid during
the brew cycle.
• Do not brew without K-cup
®
holder in place.
• Do not brew a second time
through the same K-cup
®
.

10
9. Place a coffee cup or
travel mug (up to 10oz)
in the dispense area on
the drip tray. Press the
BREW button.
10. When the water
reaches the perfect
brewing temperature,
the brewing will
begin.
11. Enjoy!
NOTES:
A. Drip Tray can
be removed to
accommodate larger
mugs.
B. It is normal to hear
gurgling noises from
the Water Reservoir, it
is part of how this unit
operates.
C. Pump will remain on
for up to 90 seconds
to complete brewing
and drying the K-Cup®
Pack.
7. Lift lid to the Water
Reservoir and fill with
filtered or bottled water
up to the desired fill
level without exceeding
the MAX fill line.
8. Close the Water
Reservoir Lid.
NOTES:
A. Always brew with
Reservoir Lid closed.
B. Unit will brew out
all water added to
Reservoir. Ensure
the cup or mug can
contain all the liquid
added to Reservoir.
C. Any spills outside the
fill area will flow to the
Drip Tray.