Murrelektronik xtreme DB DP-34005-12 User manual

xtreme DB Programming Kit
DP-34005-12 User Guide

| CONTENTS
Module Overview 3
Installing the Software #
Connecting the Universal CAN Gateway #
Downloading the Firmware #

3
| INSTALLING THE SOFTWARE
1. Go to murrmsp.com 1. Go to the xtremeDB page
1. Downlaod the DP Loader software 1. Unzip the DP Loader le and save that le in the location of
your choice

| CONNECTING THE UCG
2. Open the xtremeDB Programming Kit 3. Locate the UCG (Universal CAN Gateway) Module
4. Connect the USB cable to the UCG and a USB port on your
computer
5. Connect the M12 cable to the UCG module and the Deutsch
connector to the CAN port on your module.
1.Isolate the xtremeDB module whose rmware you will be updating from the CAN network.

5
6. Connect the wall pack power supply 2 pin Molex connector to
the mating connector attached to the Deutsch cable. Plug the
power suppy into a 120V AC outlet.
7. Install the terminating resistor into the other unused CAN
port.
8. The UCG is ready to use.

| DOWNLOADING FIRMWARE
1. Find the DP Loader icon and double click. Depending on
where you’ve saved the software this location could be dierent.
2. The program will open, press the “open” button to nd the
.hex le to download.
3. This window will open, browse to the location of the .hex le.
The last 4 numbers of the le name are the version
3. This window will open again, press the “connect” icon in the
top left corner.

7
6. This screen will appear, press the “Yes” button.
7. The screen will display “Programming” in the lower status bar.
The rmware download is now in process.
8. The screen will display “Success in X seconds!” in the lower
status bar. At this point the rmware download is completed,
you may close the window, thus closing the program.
5. You will notice the icon has turned red and the lower
status bar shows your connected at the corresponding baud
rate. Press the “Auto Program” button.

9