MUX Switchboard User manual

www.mux.life
Switchboard
Product and Installation Guide

Product Overview
- App Control
- Voice Control (compatible with Amazon Alexa and Google Assistant)
- Smart Scheduling and Automation
- Timers
- Smart Scenes
- Real time status notification
- Remote Management
Features
Refer to the following steps for installation of the Mux Switcboard.
Installation and Wire Connection
Pre-Requisite for Installation
- A neutral wire.
- The electrical box must be two (2) inches deep.
- Electrical Tester.
- Screw Driver.
- Screw Nuts (available with the product).
- Electrical box dimensions 3.3x3.3x1.5 inches.
Mux Switchboard is a Wi-Fi enabled smart device, which allows you to control
lights and multiple electronics via the Mux Life App. Additionally you can set
timers, apply schedules and control the devices via virtual assistants. Detailed
statistics help you monitor the usage of your devices.

Switch buttons
with LED status
Front Side
Back Side
Live / Hot Wire
Screws
Neutral Wire
Wi-Fi information
Out / Half (1)
Out / Half (2)
Out / Half (3)

Switch off the power at the circuit breaker
that controls the light switch.
Use voltage tester to confirm no voltage is
present.
Step 1
If you have met the above electrical requirements, proceed with the installation:
Unscrew and Remove existing switch board.
Step 2

Identify Live, Load, Neutral and Ground lines.
Step 3
Step 4
Connect the Smart Device to your sub-box wiring as shown in the table.
N - Black Wire
L - Red Wire
L1 - Red Wire
L2 - Red Wire
L3 - Red Wire

LLive / Hot Wire
Neutral Wire N
L1
L2
Mux SwitchboardSub-box Wiring
Out / Half (1)
Out / Half (2)
L3Out / Half (3)
The table shows sub-box wiring details
Step 5
Fix the Smart Device to the wall
and look for LED status.
For LED status, see the table on back
side.

To put the device in reset mode, press and hold the power button of the device
for 6 seconds (until the blue LED starts flashing). The device is now in the reset
mode. You can now add the device in to your Mux Life account.
Reset Device
Fast Blink (< 0.5 sec)
Slow blink (1 sec)
Stable ON
LED Light LED Status Wifi Status Description
Device in
Broadcast Mode
You can add the
device into your Mux
account after
resetting it.
Very fast blink
(0.03 sec)
Device already
added in mux life
account and looking
for the saved Wi-Fi.
Check the power
connection of your
Wi-Fi routers where the
device was connected.
Device connected
to Wi-Fi but has no
internet access
Check internet
connection on the
Wi-Fi Router where
device is connected.
Device can perform all
actions.
Device correctly
configured
Product LED Status
Blue Light

Caution
Scan the QR code to watch an installation video to setup Mux Life App.
App Setup
- Wrap electrical tape around the wire nuts to make sure the copper conductor
is fully concealed.
- Do not install the Smart Device with wet hands or when standing on wet or
damp surfaces.
- If you cannot find out a Neutral Line in your power line socket, consult with a
professional electrician or contact our service team.
Download the Mux Life App from the Google Play / App Store or scan the QR code.
App Download