MW MW-CTR-LUNA230 User manual

MW-CTR-LUNA230
INSTALLATION MANUAL:
MW-CTR-LUNA230-1SS1C is a special design set to p ovide emote switch on/off 230V elect ical devices. It's no
need to use cables between switch and cont olle . It's ve y usefull in LED lighting systems.
Wa ning!
The 230V elect ical connection need to be done by an elect ician with
pe mission to connect.
The kit include:
1.wireless remote switch (self powered)
2. controller
3.Screws and adhesive tape.
1. Connect the load to OUTPUT L N terminal. Pay attention to do not connect higher load then rated output
power (1000W in resistance load 200W in inductive load)
L – Live wire N – neutral wire.
15.12.2020 www.mwlighting.pl MW-CTR-LUNA230-manual_EN-R1 1

MW-CTR-LUNA230
2. Connect the mains supply wires to INPUT L N terminal. Du ing connection mains voltage cannot be be
connected.
3.Switch on the mains power supply and you can start pairing procedure.
For pairing push the switch button on the controller for 3 seconds after power-on. . LED will start flashing. Then
push the remote switch once.
Attention: Fo one cont olle , you can pait up 5 emote switches. If you sta t to pai mo e then 5 (6,7....), then acco ding
the FIFO ulez fi st p eg ammed switches will be cancelled automatically f om cont olles memo y.
4. Using the adgesive tape or mouting screws install the switch to indoor flat surface.
5. Using flat screwdriver you can open the switch front case to estetic montage.
15.12.2020 www.mwlighting.pl MW-CTR-LUNA230-manual_EN-R1 2

MW-CTR-LUNA230
6.After correct connection and pairing the controller will switch the load ON/OFF alternately just after push the
switch button.
Notiice:
One controller can work with up 5 switches located in different places.
One switch can work with few controllers.
The range is 50m in close area and 200m in open area.
Installation in metal case can reduce the range a lot.
15.12.2020 www.mwlighting.pl MW-CTR-LUNA230-manual_EN-R1 3