LED Function:
Blue LED is used to indicate the receiver operating status:
The blue LED flashes quickly to indicate that the receiver is in the connected state;
The blue LED flashes at a low speed to indicate that the receiver is waiting for a signal from the transmitter; The
The blue LED is solid to indicate that the receiver has received the transmitter's signal and is working normally;
Yellow LED is used to indicate the working status of the gyro:
The yellow LED off indicates that the gyro is off or no gyroscope;
The yellow LED is solid to indicate that the gyro is working, where low brightness means that the working
direction of the gyro is NOR, and when the high brightness indicates that the working direction of the gyro is REV;
Red LEDs indicate Transponder operating status:
The red LED off indicates Transponder off or no Transponder;
The red LED is solid to indicate that Transponder is working;
LNA Function:
LNA is an electronic component whose function is to improve the operating distance and response speed of the
receiver. Some models of transmitters transmit power too much small, then the receiver using LNA is significantly
improved in terms of operating feel and response speed, which is more conducive to drift and speed.
BIND Operation:
First power on the receiver and then press the binding switch until the blue LED flashes quickly, then power on
the transmitter. When the blue LED on the receiver changes from fast flashing to constant light, it means that the
binding operation is successful and the signal has been received.
Switch between 3.4ms and 6.8ms Mode:
RXC52-SP&TP / RXC52-SG&TPsupports two output modes of 3.4ms and 6.8ms, and users can freely switch
between these two output modes.
If the user's transmitter is T7PX or T10PX, the receiver works in 6.8ms mode when it is set to SFHSS analog mode,
and works in 3.4ms mode when it is set to SFHSS digital mode.
If it is other transmitters, the receiver works in 6.8ms mode when S-FH (NORM) is selected in the RX MODE menu
of the remote controller, and the receiver works in 3.4ms mode when S-FH (HIGH) is selected.
Set the built-in GYRO sensitivity and working direction:
RXC52-SG&TP uses the CH3 of the transmitter to set the sensitivity and direction of the GYRO.
When the CH3 signal is less than 1.4ms (Yellow LED High light), the direction of action of the GYRO is to the left,
and at the same time, the smaller the width of the CH3 signal, the higher the sensitivity of the GYRO.
When the CH3 signal is greater than 1.6ms (Yellow LED is low light), the direction of action of the GYRO is to the
