How to connect your D220 with Bluetooth
Make sure the Bluetooth on your mobile phone is ON (activated). Switch ON your D220 and wait for
a few seconds until it completes the initialization.
Step1: Select “Bluetooth” from the CONNECTION TYPE menu. The D220 will scan for all available
(discoverable) Bluetooth devices in its range and will display a list of their names on the screen.
Step 2:Choose your mobile phone's name from the list and select it by pressing its respective
number (from 1 to 6). If there are more than 6 available devices on the list, you can switch to the
next page of the list by pressing SETTINGS. If you cannot find your mobile phone on the list, press (X)
and D220 will rescan (search again) for all available discovered devices. Make sure your mobile
phone is in a discovered mode.
Depending on the device, you might have to tap “Pair device” to accept the password. The password
is shown on the myPOS device screen.
Step3: Pair the D220 with your mobile phone. Once it has been paired, D220 will perform a test of
the connection to myPOS system.
If the connection test is unsuccessful, the D220 screen will display an error message. Please, check
and make sure your mobile phone is connected to the Internet.
When you pair D220 with a Bluetooth device, the information is saved so that the next time you are
within the range of the same Bluetooth device, the terminal will connect to it automatically.
How to connect your D220 with Wi-Fi
Make sure the D220 is in the range of your Wi-Fi network. Switch ON your D220 and wait for a few
seconds until it completes the initialization. If you see the screen CONNECTION TYPE, please proceed
to Step 1 below. If you are in the Bluetooth Menu please press (<) to return to CONNECTION TYPE
screen and proceed to Step 1 below. Otherwise please press (X) to exit from the current operation,
then press SETTINGS to enter SETTINGS MENU 1 and choose Change Connection type (3).
Step1: Select “Wi-Fi” from the CONNECTION TYPE menu by pressing (1). The D220 will scan for
available Wi-Fi networks within its range and will display a list of their names on the screen.
Step2: Find the Wi-Fi network you would like to use and select it by pressing its number (from 1 to 6).
If there are more than 6 available networks on the list, you can switch to the next page of the list by
pressing SETTINGS. If you cannot find your Wi-Fi network on the list, press (X) and D220 will rescan
(search again) for available Wi-Fi networks. Make sure your D220 is in the range of your network.
Step3: If your Wi-Fi network requires a password, D220 will display the Wi-Fi Password screen, where
you can enter the network password. In case your password contains digits, press the relevant
number key. In case your password contains letters or other symbols, press the relevant number key
and then press F2 as many times as necessary until the correct letter is reached and displayed. If you
