Myron Mixon Smokers MAMMCG2020 User manual

SAFETY NOTICE
CARBON MONOXIDE HAZARD
Burning charcoal inside can kill you. Burning charcoal gives off carbon monoxide, which
has no odor and can cause death.
DO NOT burn charcoal inside homes, vehicles, tents, garages or any enclosed areas.
Use only outdoors where it is well ventilated.
MODEL MAMMCG2020
Myron Mixon Charcoal Grill
KEEP THESE INSTRUCTIONS FOR FUTURE USE.
WARNING
This manual contains important information necessary for the proper and safe use of
this charcoal grill
Read and follow all safety statements, warnings and instructions before using charcoal
grill and during use.
Do not store or use gasoline or other flammable Liquids or vapors in the vicinity of this
or any other appliance.

2

3
DO NOT; burn on wood
surface or any surface which
is combustible or flammable!
Check with your local
municipality or fire district
before using an outdoor
charcoal burning grill!
DO NOT; use indoors! The
Myron Mixon charcoal grill
is designed for outdoors
use only! If used indoors,
toxic fumes will accumulate
and cause serious bodily
injury or death!
When using the Myron
Mixon charcoal grill exercise
the same caution that you
would with camp fire!
Your Myron Mixon charcoal
grill is hot while burning!
Use extreme caution with
children and pets when grill
is burning!
NEVER; start a fire with
gasoline, kerosene, diesel
fuel or any other petroleum
based accelerants!
DO NOT; use your Myron
Mixon charcoal grill under,
on and around any overhead
construction or low hanging
branches, dry grass, brush
piles, wood piles, awnings,
wood furniture, propane,
flammable gasses or vapor,
paper, compressed paper,
plastic, Plexiglas or anything
combustible.
DO NOT; operate your
Myron Mixon charcoal grill
unless it is on level surface!
DO NOT; use your Myron
Mixon charcoal grill in a
garage, building breezeway
or any other enclosed area!
Position your Myron
Mixon charcoal grill so that
it is shielded from strong
wind and gust!
(4'-FourFoot)
must be maintained from any
combustible materials while
in operation. Follow local
codes and specific safety
instruction for your area.

4
Its highly recommended to
use heavy duty gloves when
handling coals or lid.
DO NOT; leave your
Myron Mixon charcoal
grill unattended! Keep a
fire extinguisher on hand
when you have a fire going.
DO NOT; store the Myron
Mixon charcoal grill with
combustible materials or
ashes inside.
Make sure the charcoal
grill is not in use and has
cooled down, then use a
cloth to remove the soot.
Some parts may contain
sharp edges. Wear
protective gloves if
necessary. Wash your hands
after handling this product.
DO NOT; burn pressure
treated wood in your
Myron Mixon charcoal
grill . These items produces
toxic gases that can be
harmful.
DO NOT; move your
Myron Mixon charcoal
grill while it is burning!
Use caution when
removing ashes and coals
from charcoal grill,
Dispose ashes in tight
sealed metal container, use
dirt or sand to smother the
ashes out.

5
Installation Instructions
Tools Needed:
• Phillips Head Screwdriver
• Hammer
• Drill with a 7/16” socket driver or a socket wrench
with 7/16” socket or a 7/16” wrench.
1. Unpack all the parts and lay them out neatly so you
can see all your parts.
2. Lay the main grill body on its right hand side like
pictured below. If you have the space you can place
the main grill body on a corner of a table as well.

6
3. Take one of the shorter rear legs and two J nuts and
snap them into place as shown.
4. Place the rear leg next to main grill body with the J
nuts side up against the body like shown below.

7
5. You may need a second person to help you. Now reach
inside the grill and line up the leg predrilled holes with
slots in the bottom of the grill body. Now run the 3/4”
bolt through like shown below. Leave the bolt a little
loose so you can move the leg a little to line up flush
with the side of the main grill body.
6. Repeat step 5 with the other rear leg.

8
7. Take the bottom base and place it with the holes that
are on top of the base towards the rear legs. Align the
holes up and use 4 of the 1/2” bolts to run through the
legs into the base. As shown below.

9
8. Take the longer front legs and put the J nuts on them
like in step 3. Repeat step 5 and 6 securing both front
legs to the main grill body. The leg will go longer than
the bottom base like shown below. Take 4 of the 1/2”
bolts and attach the leg to the bottom base.

10
9. Take the 1/2” rear axle and slide one wheel on the
axle like shown. Slide the axle through the bottom base
plate by the rear legs. Slide the other wheel onto the
axle and attach the silver cap onto the axle with a
hammer.

11
10. Now with help stand the grill upright like shown.

12
11. Take the right side tray shown below and attach with
4 of the 3/4” bolts. If your using the optional stainless
front tray leave the two front bolts loose. Otherwise
tighten all bolts down.

13
12. Take the left side tray and repeat step 11.

14
13. May require two people. Take the handle shield and
handle shown below and take the 2 Philips head screws.
Run the screws through the handle shield through the
grill lid and into the handle. Before you tighten the
screws flush up the lid sides with the lip on the handle
shield see below. The handle shield is slotted to allow
movement to line up.

15
14. Lay the ash pan in the bottom of the grill like shown
below.

16
15. Take the two charcoal pan holders shown below
and place them on the bottom row of angle iron first.
You must go all the way to the bottom first because the
main grill body gets in the way if you try to go to the
top ones first. Now if you want to slide them onto the
top angle iron pieces for searing purposes you can.
You can have one lower and one higher if you’d like
or both high. Then once the grill cools slide both back
down to the bottom to remove them to get to the ash
pan to dump your ashes out.

17
16. Place the cooking tray onto the grill laying on the
inside bends like shown.

18
17. If you have the optional extra cooking rack place it
on top of the regular cooking rack like shown below.

19
18. If you are using the optional front shelve. It hooks
over the bolts on the sides from the side trays that you
left loose. Slide it in and tighten the 4 front bolts.

20