MyStuff WalkingPad P1 User manual

MyStuff.no
[phone]
www.mystuff.no –[e-mail]

User Manual
Content
WARNING
Electric shock hazard, where the appliance is used without the earth connection.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
To reduce the risk of personal injury, read and understand all the instructions before using this product.
1. Product and Accessories 02
2. Function schematic diagram 03
3. Guide for initial operation 07
4. Learn to use WalkingPad 09
5. Safety Notice 13
6. Maintenance and Service 16
7. Trademark and Legal Declaration 17
8. Replacement and Disposal 18

Welcome to use
01 Product and Accessories
01
02
Thank you for choosing the WalkingPad Walking device, hereinafter referred to as a WalkingPad, which possess various
advantages including exquisite, foldable, innovative integral design. From now on, enjoy the quality life of walking at home.
Please carefully check whether the contents of the package are complete and intact. If there is any missing or damaged, please
contact the seller.
Main Product
Parts
Power Cable
User Manual
Performance &indicators
Detailed parameters
Detailed parameters
1432 x547 x129mm
56.5'' x 21.5'' x 5''
Folding dimensions
822 x 547 x 129 mm
32.5" x 21.5" x 5"
Walking Area
1200 x 415 mm
47" x 16.5"
Gross weight
31 kg / 68 lbs
Net weight
28 kg / 62 Ibs
Maximum load
100 kg / 220 lbs
Applicable age
14 ~ 60 years old
Applicable height
Unlimited
Minimum speed
0.5 km/hr 0.5 mi/hr
Maximum speed
6 km/hr 3.75 mi/hr
Power Input
746 W
Frequency
60 Hz
Rated voltage
220 - 240 V ~
Sport mode
Standby mode/ Manual
mode/ Automatic mode

Welcome to use
01 Product and Accessories
01
02
Other accessories
Remote Controller Lanyard Wrench Silicone Oil

02 Function schematic diagram
03
04
1. Product main body
WalkingBelt
Fold Hinge
Roller
Power Switch
Power Plug
Roller
Mode Switch

02 Function schematic diagram
05
06
2. lntroduction of the function of the indicator panel 3. WalkingPad remote control
DisplayTime Display Speed Display Distance Display Steps
Standby Mode Manual Mode Automatic Mode
DISPLAY SCREEN
START/STOP
LANYARD
ACCELERATION
DECELERATION
MODE SWITCH
BATTERY COVER

03 Guide for initial operation
07
08
1. Choose flat ground to place the
WalkingPad. It is forbidden to
place it on thick and soft cushion.
Please note: Don't connect the
power before the WalkingPad is
fully unfolded.
2. Unfold the WalkingPad slowlyand
press it down to completely flat. 3. Check and adjust the walking belt to make sure it's centered. 7. Enter novice guide. 8. Complete Novice Guide to unlock all Functions ( maximum speed
3.75 mi/hr ). Otherwise the speed
limit remains at 1.75 mi/hr.
9. Start to use the WalkingPad.
Mode Switch
4. Connect the power cord and
press the button to switch on. 5. Search ''WalkingPad" App from Apple Store or Google Play and
complete installation.
6. Open the App, follow theprompts
to set up the device. 10. If the belt deviates from theorbit in use, please adjust properly.
SEE: 06 Maintenance and
service.
11. Short press: return to the previous mode.
Long press: switch to Standby mode.

04 Learn to use WalkingPad
09
10
1. Mode instruction 2. Instructions of the standby
mode control 3. Instructions of manual mode control (primary mode)
Standby Mode
Light of the Standby mode is on;
Motor and sensor stop responding.
Manual Mode
Light of the manual mode is on;
Control the speed through the remote
control or APP.
Automatic Mode
Light of the automatic mode is on;
Speed is automatically controlled by
intelligent algorithm.
It follows the speed of walking.
Standby Mode
The motor and sensor stop responding
in this mode to prevent nonusers from
accidentally triggering the WalkingPad.
Mode Switch
Short press: return to the previous mode.
Manual Mode
In this mode, the speed of the WalkingPad can be controlled by the remote
control. It is recommended that beginners use the manual mode first and then
use the automatic mode after being skilled in using the WalkingPad. The
manual mode is controlled by remote control by default, that is, the
START/STOP button of the remote control is used to start or stop the Walk-
ingPad, which can be modified in the client "Personalized".
ACCELERATION
Short press: increase speed by 0.25 mi.
START/STOP
Short press: Start or Stop the WalkingPad.
DECELERATION
Short press: reduce speed by 0.25 mi.
MODE SWITCH
Short press: switch to automatic mode.
Long press: switch to Standby mode.
In the manual mode, set as
the intelligent start and stop,
the WalkingPad will start
automatically to the target
speed (default is 1.75 mi/hr )
while entering this area.

04 Learn to use WalkingPad
09
11
4. Description of automatic mode control (advance mode) 5. Remote Controller Notice 6. Error code
Automatic mode
This is a challenging and higher class mode. User can walk
on the WalkingPad completely out of remote control- ler.
We only recommend those who have good sports skills or
walking machine experience to take the challenge.
Short press: stop the WalkingPad.
Mode Switch:
Short press: switch to manual mode.
Long press: switch to Standby mode.
If the remote controller has no response or you change a
new one, the remote controller and walking device need to
re-establish communication.
Remote control pairing method:
Restart the WalkingPad, press and hold down the mode
switch button on the remote control immediately, hearing
the sound of "Beep" indicates the success of pairing. Note:
During the operation, the remote control should be close to
the WalkingPad.
The error code is off when the walking machine is work-
ing normally. While error occurs, the display panel of
remote shows the error code.
E01: Drive communication fault;
E02: Motor abnormalities;
E05: Overcurrent protection;
E06: Motor Protection;
E08: Sensor Fault;
E09: Controller connection failure;
E10: High temperature protection, automatic recovery
after the end of countdown;
E11: Overload protection, please add lubricating oil, and
resume automatically after countdown.
Entering this area, the
WalkingPad will start or
accelerate under the
automatic mode.
Entering this area, the
WalkingPad will slow down
automatically under the
automatic mode.

05 Safety Notice
13
14
Please keep a rear distance of
1000 mm or more. Please choose sport shoes. Please do not stand up on the walking machine when it is
under auto calibration situation.
Anti-pinch. Turn the power off before foldup
the WalkingPad. Prohibition of vertical placement.
Please keep a distance of 500 mm
or more for both sides. Using on uneven groundis
prohibited. It is strictly prohibited to walk
up and down the walking
machine when running.
Anti-involved, please do not
trample. Please pull out the plug whenyou are not using it. Prohibition of lateral placement.

05 Safety Notice
06 Maintenance and Service
15
16
1. Clean the walking machine - Turn off the machine and unplug the power cord.
- Add several drops of detergent on cotton rag or towel. Don't pour the detergent on the
belt directly, and don't use acid or corrosive cleaners.
- Wipe off dust and stains on the frame, front panel and belt. Do not wipe backside of the
belt.
- After using for a period, dust and stains may appear on the back part, that is normal
situation, and just clean them up.
Please keep your sight
horizontal to avoiddizziness.
Children should be
supervised to ensure that
they do not play with the
WalkingPad.
More than one person
on the WalkingPad is
prohibited.
Walking sideways on
the machine is
prohibited.
Using machine with
pet is prohibited.
Walking backwardson
the machine is
prohibited.
Trampling the machine
head is prohibited.
Please do not use the
walking machine if you
are aged people or
pregnant women.
2. Adjust the belt
3. Lubricate the Belt
- Press and hold both Mode Switch Button and Acceleration Button on the remote control
over 3 seconds.
- The walking belt will move at the speed of 4 km/hr ( 2.5 mi/hr ).
- If belt deviates to the left: Turn the left adjusting screw for a half-circle clockwise.
- If belt deviates to the right: Turn the right adjusting screw for a half-circle clockwise.
- If belt is slipping: Turn both left and right adjusting screw for a half-circle clockwise at
same time.
- Keep the machine running for 1-2 minutes and check whether it needs toreadjust.
- Turn off the machine and unplug the power cord.
- Lift up the belt and apply silicone oil on the backside of thebelt.
- Turn on the machine again
- Keep the machine running under 4 km/hr ( 2.5 mi/hr ) for 10-20 20seconds.
- Only apply 5 ml ~ 10 ml lubricant oil each time, too much lubricant oil makes the belt
become slipping.
- Apply for silicone oil once every 3 months.
Horizon

07 Trademark and Legal Declaration
08Replacement andDisposal
17
18
Beijing Kingsmith Technology Co., Ltd holds the patents of Walkingpad Walking Device series products. Kingsmith edits and
owns the copyright of this manual book. Without Kingsmith's written permission, any form of unauthorized distribution, reproduc-
tion, publication, release or quotation by any institution or individual is prohibited. This manual contains as many as possible of
all the functions and instructions for use. However, due to product imperfections, design changes, etc., the description may still
have discrepancies with what you have purchased. In view of product updates, description in this manual book may differ from
what you have purchased in color, appearance, etc. Actual supplies prevail. This appliance is not intended for persons (including
children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance. Children aged from 8 years and above and persons can use this
appliance with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understood the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not be made by children withoutsupervision.
Product performance standard : Q/FTSMS0001-2017
The battery contained in this appliance must be removed for or disposal.
When replacing the battery, use only original battery, available from the parts shop.
The battery can be replaced by open the back cover, be aware of the polar mark while inserting a new battery.
Never dispose of old batteryindomestic garbage, but only through the proper public collection points.This also
applies to the battery of defective appliances.

08 Replacement and Disposal
19
Devices marked with this symbol must be disposed of separately from your household waste, as they contain
valuable materials which can be recycled. Proper disposal protects the environment and human health. Your
local authority or retailer can provide information on the matter.