N-BIOTEK NB-206CXL User manual

CO2 SHAKING INCUBATOR
MODEL : NB-206CXL/206CXXL
OPERATING MANUAL

www.n-biotek.com N-BIOTEK
OM-NB-206CXL / NB-206CXXL (Ver. 2020) 2/24
- CONTENTS
Page
1. Introduction
1.1 Warranty 3
2. PRECAUTION
2.1 Precaution for electricity 4
2.2 Precaution for installation 5
2.3 Precaution for use 6
2.4 Precaution for ground connection 7
3. FEATURE AND SPECIFICATION
3.1 Features 8
3.2 Specification 9
3.3 Configuration 10~11
4. INSTALLATION AND OPERATION
4.1 Control Panel of Incubator 12
4.2 Installation 13
4.3 Operation 14
4.4 Calibration 15~17
4.5 Overheating Protection 18
5. SHAKER OPERATION 19~22
RPM, TIMER, Max Load, Sliding Platform
6. ALARM 23
7. DRWAING OF APPREANCE 24

www.n-biotek.com N-BIOTEK
OM-NB-206CXL / NB-206CXXL (Ver. 2020) 3/24
1. INTRODUCTION
Thank you for purchasing our Anicell, CO2 incubator and Shakers.
This operation manual includes practical information such as performance, usage, and
cautions and notices for use of the product.
So, before using the product, please read it carefully all the safety instructions described
in this manual and keep this manual for future use.
N-BIOTEK provides a warranty on all parts and factory workmanship. The warranty
includes areas of defective material and workmanship, provided such defect
results from normal and proper use of the equipment.
1. The free warranty service will be provided once the unit is proved to be defective
by wrong workmanship after NBIOTEK or reliable distributor’s examination.
2. The warranty period is 1 year from date of installation or 1 and Half year from the
date of shipment from NBIOTEK, whichever is sooner as indicated in above table.
This period is proved by serial no.
3. NBIOTEK will not be responsible of free warranty service for the faulty caused by
user’s improper operation, excessive use, use of incorrect voltage & frequency,
storage in wrong environment mentioned in Manual.
4. Complete the above table after installation and keep this card. Then, present it to a
dealer or NBIOTEK when warranty repair is needed.
Signed By
Item
Anicell
Model
NB-206CXL / NB-206CXXL
Date of
Installation
mm-dd-year
Supplier
Serial NO.
Period
1 year
W A R R A N T Y

www.n-biotek.com N-BIOTEK
OM-NB-206CXL / NB-206CXXL (Ver. 2020) 4/24
2. PRECAUTION
■Precaution is to prevent the possible accident or danger during operation.
So, you must keep it.
■Precaution is separated into caution and warning.
And, each of them has following meanings.
■Other Marks
2.1 Precaution for electricity
------------------------------ WARNING------------------------------
Use this product only internally. (220V, 60Hz)
(If the product is used at the place in different power pressure, it causes a fire and malfunction
of the product.)
Do not make the power plug be pressed by back of the product.
(A space between the product and the plug must be 20cm at least.)
The power outlet must be only for this product.
(Using various products simultaneously can cause a fire)
Clean the power plug with a dry towel and connect it properly.
(Foreign substances or unsafe connection can cause a fire.)
Do not bend the power cable harshly and do not make it to be pressed by heavy products.
(When it is damaged, it can cause a fire.)
Do not touch the power code with wet hands. (It can cause an electric shock.)
Do not use the damaged power code and outlet.
(It can cause an electric shock and a fire.
When the smoke comes out from the product or smell something is burning or any other
strange symptoms are occurred, pull out the power code and stop using it.
(It can cause an electric shock and a fire.)

www.n-biotek.com N-BIOTEK
OM-NB-206CXL / NB-206CXXL (Ver. 2020) 5/24
2.2 Precaution for installation
-------------------------- WARNING ------------------------------
Use it with the proper voltage.
Please check the voltage & Hertz written on serial label.
(Over-voltage, low-voltage can damage the product and poor performance.)
Do not install at a humid place.
(It causes an electric leakage accident and a corrosive of the product.)
Keep this product out of the direct ray of sun and do not install at a hot place or a place that is
near an electric heat.
(The proper indoor temperature is 20℃ ~ 30℃.)
Do not put inflammable substances near the product.
(It can cause a fire)
------------------------------ CAUTION ------------------------------
The product requires the distance of at least 20 cm from the wall for well ventilation.
(When ventilation works well, you will use the product satisfyingly regarding a cooling
ability and a heat.)
Install at a flat and solid place
(If the ground is not flat, it causes a vibration of the product.)
When you move the product, you must hold up the product.
(Pushing or pulling the product can damage the bottom part of the product.)
When the movement of the product is required, please tie up the door and other movable part
with a tape.
( Able to get an injury by opening door and get a damage of the product.)