N-FLATABLES Belly Bouncer Fire Dog User manual

Supplement Manual v4.12 ©2012 Great Air, Inc. dba N-Flatables
Safety Notice
All materials have been tested and comply to NFPA 701 Large Scale Test and the
California Title 19 fire rating test. This Inflatable Amusement Device complies to
the ASTM F2374-10 standards for safety, where applicable to the specific use of
this Inflatable Device. Instruction Supplement and General Installation Manuals are
included with this unit.
It is YOUR RESPONSIBILITY to read and follow these important instructions to
prevent injury for your patrons using this device!
Minimum CFM requirement for this inflatable is 810 CFM. NO Maximum CFM is
applicable.
All information included in this supplement is kept current and up-to-date. N-Flatables
reserves the right to update this information from time to time as needed.
! !
! !
* All outdoor weight containers MAY NOT comply with all state or
municipal tethering requirements for inflatable devices.
ALWAYS contact the utility company
before pounding stakes into the ground!
Cutting•Edge•Creations
2955 Lone Oak Circle, Suite 7
Eagan, MN 55121 USA
Toll Free 1-800-811-7002 • Local 651-209-8600 • Fax [phone]
www.cuttingedgecreations.com
BELLY BOUNCER™DImensions: (H x W x L)
Belly Bouncer™
Congratulations on your purchase of the Belly Bouncer™ .
This supplement applies to the following Belly Bouncers™:
Cow Raccoon Turtle Bear Beagle
Horse Party Pig Elephant Tiger Panda
Gator BBQ Pig Dino Hop on Pop Unicorn
Cutting•Edge•Creations knows that you’ll get many hours of excitement from
your new purchase. Please read this booklet carefully, being sure to read
all of the safety precautions and the do’s and don’ts of the ride.
Remember to stake (tether) your Belly Bouncer™as described in the
“Installation and Setup” booklet, and be sure to have a minimum of (1)
trained operator as defined in the booklet.
Once again, we thank you for doing business with us, and call us if you
have any questions.
Sincerely,
N-Flatables / Cutting•Edge•Creations
The correct procedures for
installing and operating
of this inflatable unit.
• High Volume Output.................................1.0-1.5 hp; 810 CFM
This Unit Requires 1Blower(s) to Function Properly.
CEC Suggests the following Blower Types:
Belly Bouncer™
1-Piece Unit includes: Entrance
ramp, large zipper entrance, auxil-
liary blower sleeve, tether kit, mat-
tress reinforcement strips and car-
rying bag. Recommended load:
(6) patrons over 34" tall, maxi-
mum height not to exceed 60"
tall, 150 lbs. suggested maximum
weight per patron.
Fire Dog (#BC131501) ............. 14'x25'x16'
Cow (#BC131103)...................... 12'x25'x16'
Gator (#BC130601) .................. 14'x25'x16'
Raccoon (#BC130401) ........ 13'6"x25'x16'
Turtle (#BC130501) ...........14'x21'4"x17'6"
Bear (#BC131401)..................... 14'x28'x16'
Beagle (#BC131201)................. 14'x25'x16'
Horse (#BC130701) .................. 14'x28'x16'
Party Pig (#BC130102)............ 14'x22'x16'
Elephant (#BC130901)............ 14'x25'x16'
Tiger (#BC130301).................... 14'x25'x16'
Panda (#BC130601) ................. 14'x28'x16'
BBQ Pig (#BC130101).............. 14'x22'x16'
Dino (#BC131001) ..................... 14'x25'x16'
Recommended
Number of
Installers
Number
of
Operators
Maximum
Number of
Patrons
1 1 6
Minimum
& Maximum
Height
No. of Stakes
& Minimum
Stake Length
Indoor
Weight
Container
Anchors
75%
Buried
Outdoor
Hard-
Surface
Anchors*
Max Suggested
Weight per Patron
150 lbs.
Total Patron
Weight
900 lbs.
Use Whistle for Control
(4) 24" Long (4) 400 lbs.
34"
Min.
60"
Max.
100 lbs.
Per Container
(4) 600 lbs.
150 lbs.
Per Container

Static
Dimensions
(in bag)
Dynamic Dimensions
(inflated)
B = Bottom Tether
ENT = Entrance
= Evacuation
KEY TO DIAGRAM
ZIP = Deflation Zipper
EXIT = Exit
OP = Operator Position
= Blower
Locations
BL
T = Top Tether
Directions
•Read instruction booklet.
•Remove unit from storage bag.
•Position on a level ground area approximately 22' x 34'.
•Install ground stakes, at least (4) around perimeter.
•Loosely tie tethers to ground stakes.
•
Attach (1) Blower to tube, making sure velcro strap is firmly secure.
•
Close zipper flaps on rear of unit to make sure it is closed and secure.
•Connect blower to its own power source.
•Blower systems requires a 20 amp service each.
•Turn blower on and guide the unit until inflated.
•Secure all tethers after the unit is fully inflated.
•Do a safety check of blowers, slide & climb covers.
•Do not operate in winds over 20 mph.
NEVER LEAVE THIS RIDE UNAT TENDED!
50"
50"
50"
*16'
*
Catastrophe!
This type of catastrophe can always
be avoided by proper tethering,
utilizing 24" long ground stakes, and
by having trained operators on duty
and avoiding inclement weather
(such as high winds i.e. winds in
excess of 20 m.p.h.).
Important Notice:
Specifications for Inflatable Devices may change based on reconfigura-
tions that may be required for the proper use of an inflatable device.
These changes may include, but not be limited to, the following:
1) Maximum Heights of Patrons.
2) Minimum Heights of Patrons.
3) Number of Patrons (on a device at one time).
4) Maximum Weight
5) Number Of Stakes
6) Size of Stakes
7) Number of Blowers
8) Overall physical dimensions of the device.
Any noted current changes made to any inflatable device will be updated
on our website: http://www.cuttingedgecreations.com.
POSITION STAKES ABOUT
3' FROM INFLATABLE. DIAGRAMS ARE
NOT TO SCALE.
OP
TOP VIEW
SIDE VIEW
B
T
ZIPPER
BLOWER
EXIT
ENT
END VIEW
Belly Bouncer™
B
T
B
T
B
T
*
16'
16'
*
*
SECONDARY
BLOWER TUBE
ENT/EXIT B
TT
B
BB
T T
* indicates measurement
depending on unit purchased.
* indicates measurement
depending on unit purchased.
PLEASE REFER TO TETHER POINT LOCATIONS
ON THIS TETHERING DIAGRAM.
DAILY INSPECTION
CHECKLIST OF INFLATABLE
Check to see if blower(s) is attached properly
and securely to inflatable device.
Make sure all deflation zippers are closed and
secured.
Check blower electric attachment to be sure it
has been properly plugged in to receptacle.
Make sure blower system has no obstruction
restricting intake on sides of blower.
Check inflation of unit to be sure it is properly
inflated to correct firmness.
Make adjustments to slide and climb covers if
necessary to proper secure position.
Make sure all tether points are attached properly.
Check netted areas and sun covers to be sure
they are in place and in good condition.
Crawl through (if possible) inflated device and
examine all visible seams for stretching or wear.
If problems with any seams contact manufacturer
to advise.
Inspect the inflatable for loose stitching causing
open seams, torn netting, worn holes in bottom
or sides of unit. If found, cease use and repair
immediately using supplied repair kit. Or if a
hole or seam is open more than 1 - 2 inches,
professionally repair using 207 polyester thread
from a reputable inflatable repair center.

Make sure all operators understand the proper procedures for
using this inflatable, and that passengers must follow the rules.
Deflation Rate of Inflatable:
Type of Testing: Observed
Deflation Rate to unsafe conditions: 3-5 minutes.
Buyer” (person, company or entity purchasing the inflatable product or
device), is solely responsible for the manner of use of the products and other
equipment purchased from N-Flatables. “Buyer” is solely responsible for all
signage, labels and warnings to consumers or other users of the products and
equipment, and for any and all other acts necessary, including user warnings
and limitations (e.g., weight, height, age, number of participants and medical
condition limitations), to ensure the safety of the users. “Buyer” acknowledges
that they have received, read and fully understand all necessary instructions
for the safe setup and operation of their Cutting Edge Creations inflatable
product or device. “Buyer” agrees to operate their Cutting Edge Creations
inflatable product or device according to the instructions established by
Cutting Edge Creations. “Buyer” agrees to operate their inflatable product or
device according to all state and local requirements. “Buyer” agrees to train
any person(s) operating the inflatable product or device in the safe operation
of the inflatable product or device including safe handling of emergency situa-
tions. “Buyer” shall use proper stakes, tie-downs, and other applicable devices
necessary to ensure the safety of users and the general public. “Buyer” agrees
to indemnify, defend and hold harmless N-Flatables and N-Flatables Insurers
from actions and claims of third parties, including customers of “Buyer” and
users of the goods and products sold to “Buyer”, arising out of or in connec-
tion with the use of the goods and products herein described or resulting from
the breach of the provisions in this Confirmation of Order by “Buyer”. In the
event N-Flatables is required to commence an action to enforce this provision,
“Buyer” shall pay all of N-Flatables legal costs and expenses.
Important! Use and Indemification: !!
Watch Out for High Temps!
DO NOT operate when temperatures
exceed 90-degrees. Watch for early signs
of heat exhaustion and for dehydration.
Keep Landing Areas Clear!
Operators should not allow participants
to land on one another. Accidents WILL
happen!
Instruct Safety!
Instruct riders to follow the safety rules
located on entrance side of unit. NO
flipping, as injuries may occur!
Evacuation Procedures!
The blower tube has an automatic air flap
that reduces the loss of air if the blower
system goes off. In the event of a power
outage or emergency take-down, direct
patrons off the inflatable as shown by
arrows in the diagram shown above.
Improper use of this inflatable
may cause serious injury!
Operator Take Control…
Use
Whistle!
ASTM Standard #F7324-06 6.6.1
Operators & attendants shall
incorporate the use of whistles
or other devices or signal equip-
ment & take appropriate action
at the first sign of misbehavior
or violation of posted rules.
Step by Step Procedure:
Belly Bouncer™
1. Step onto ramp.
Children should enter on
their hands and knees.
2. Enter bouncer by going
through the netting
opening.
3. Once inside, start
jumping around on
the mattress.
4. Exit bouncer with the
help of an operator.
Be sure to leave room
between you and others!
Avoid Contact with Others!
Passengers must be instructed to use or
ride unit individually. Do NOT allow double-
riding, as accidents WILL happen!
Do Not Hit Your Head!
DO NOT dive or enter unit head first,
as head or neck injuries may occur!

ADVERTISEMENT
ADVERTISEMENT
Avoid such potential liability problems with this
information board prepared especially for the inflat-
able industry! This
durable double-
sided “A” framed
sign list the sensa-
tions that one may
experience, such
as ‘dizziness or
vertigo, possible
strain on knees
and elbows’
and ‘a bouncy
feeling with a
recoil action’,
etc...
Optional Safety sign:
“The Inflatable
Experience™”
Ask your CEC
representative
for details!
IMPORTANT NOTICES!
Manufacturer DOES NOT WARRANT THE SAFETY OF THIS DEVICE,
if used by owner or operator, in any way that violates manufacturers
safety guidelines for safe set up and operation. YOU the owner or
operator, are liable for any injuriesthat may occur because of YOUR
negligence.
DO NOT ALTER THIS DEVICE. Any repairs or alterations to this
device not performed by the manufacturer will VOID any warranty
and manufacturers responsibility for the safety of this device.
SAMPLE WARNING L ABEL
A Warning Label is placed on every inflatable that Cutting Edge
Creations produces. The image shown above is only a sample of
the Warning Label found on the side of your inflatable, and may not
represent the information pertinent to the safety of this particular unit.
Please instruct all participants to follow Safety Procedures!
SAFETY SUN COVER: The Safety Sun Cover on this device must not
be removed for any reason while the inflatable is in use. This Safety
cover maintains the structural integrity of the device while maintain-
ing a protective cover to prevent patrons from inappropriate use of
the device, which includes but is not limited to, Diving and jumping.
ADVERTISEMENT
ADVERTISEMENT
Safety Air Systems, LLC
[e-mail]
www.safetyairsystems.com
The Watchdog™blower siren is the
future for safer operation of inflatable
amusement rides. It is amazing that the
inflatable industry has gone without any
type of device for monitoring inflation.
Cutting Edge Creations, Inc., is a licensed
provider of the Watchdog Blower Siren.
Ask your CEC
representative
for details!
WATCHDOG™units are only available in 110v.
U.S. Patent #6,650,246