FCC Compliance Statements
NOTE : This equipment has been tested and found to comply with the limits for a FCC
Subpart C device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates ,uses and can radiate radio frequency energy and ,if
not installed and used in accordance with the instruction , may cause harmful
interference to radio communication. However , there is no guarantee that
interference will not occur in a particular installation.
If this equipment dose harmful interference to radio or television
reception ,which can be determined by turning the equipment off and on.
The user is encouraged to try to correct the interference by one or more of the
following measures :
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
Warning : Your are cautioned that any change or modifications to the equipment not
prissily approved by the party responsible for compliance could void your
authority to operate such equipment.
NOTE : This unit was tested with shielded cables on the peripheral device .
Shield cables must be used with the unit to insure compliance.
3